Pinnacle PWBCH0002 Manual

COMPACT WORKBENCH
WITH DRAWER
HEIGHT WIDTH
1405mm 1100mm
ITEM NO: PWBCH0002
Very Important: Unpack the unit and confirm that you have all the
parts listed. Assemble the unit on a solid, level surface. Avoid carpet.
You will need the assistance of a second person during assembly.
Safety tip:
For added safety and support we recommend you fix unit to a wall.
You will need the following:
Rubber Mallet & Phillips-head screwdriver & adjustable spanner.
Please note:
When moving shelving unit lift using the bottom leg uprights.
Parts List
D
A
E
F
B
G
H
I
J
K
L
C
Step 1
F
H
M
I
S
Place foot end caps 'S' onto the bottom of the legs 'I','J' and 'F', 'G'
Note upright position. Place shelving brackets 'M' & 'H' onto the
legs. A rubber mallet can be used to lightly tap all brackets into
the keyholes of the legs .
Step 4
E
N
D
N
N
Place bracing 'N' into slots in shelving brackets 'H'. Place wire
mesh 'D' on lower area of unit. Place MDF benchtop 'E' on the
upper area of the unit.
DEPTH
540mm
M
N
O
P
Q
R
T
S
Step 2
G
O
J
Place drawer runner base 'O', 'P' on the left and right end side
of the uprights.
Step 5
K
Place left upright 'K' into 'F' upright then repeat 'L' upright into 'G'
upright. Place pegboard 'G' into 'K' and 'L'. Place top lid 'C' on top
of pegboard 'C'.
200
kg
BENCHTOP CAPACITY
U
V
W
X
Z
Y
TT
P
C
B
TO HELP PREVENT A TIP-OVER:
Children have died from
• Anchor this product to a wall or
furniture tipover.
other suitable surface with the
• ALWAYS secure this
provided "Tip over prevention kit".
furniture with an anchor
• Check anchors regularly
device.
• NEVER allow children to
FOR MORE INFORMATION SEARCH:
stand, climb or hang on
www.productsafety.gov.au
drawers, doors or shelves.
SAFETY TIP:
When assembling or installing this product
wear protective gloves and eyewear.
A: Drawer x1 O/P: Drawer runner base x2
B: Pegboard x1 Q/R: Pegboard edge cap x2
C:Top lip x1 S: Foot end caps x4
D: Wire mesh x1 T: M6 bolt x7
U: Drawer base x1
E: MDF x1
F/G: Left/Right rear upright x2 V: Drawer handle x1
H: Long bracket x4 W: Drawer back panel x1
I/J: Left/Right front upright x2 X/Y: Drawer side x2
K/L: Left/Right pegboard upright x2 Z: M6 Nut x8
M: Short bracket x4 TT: Self tipping screws x16
N: Brace x4
Step 3
Place short brackets 'M' above drawer runners and shelving
brackets 'H' horizontally across the front and rear of the unit.
Step 6
T
L
Connect top lid 'C' to pegboard using 'T' M6 bolt x3.