Important Safeguards PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, and hyperthermia, including the following: CAUTION Read all instructions before using this heater. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction...
Page 6
WARNING Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
Page 7
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
Product Overview Handle Control Panel Cord Wrap Control Box Caster Assembly Accessories Remote Control [Note] All the pictures in this manual are for explanation purpose only. Any discrepancy between the real object and the illustration in the drawing shall be subject to the real object.
Quick Start Guide Installation of the caster plate assemblies Place the heater body inversely with the bottom upward. Tighten two caster plate assemblies to the body with wing nuts as shown in Figure 1: Figure 1 Place the heater upright after installing the caster plate assemblies. Note: Wheels should be touching the ground.
Operating Instructions Inspect Before Use The power cord shall not be damaged or fractured. Please verify the rated current of the receptacle is in line with the requirements in the table above and is equipped with a safety grounding device before use; otherwise, replace the receptacle.
Page 11
Button Function Description • Press "On/OFF icon" to turn the unit on/off. • After turning the unit off it is recommended to unplug the ON/OFF heater. • Repeatedly press "insert Mode icon" to cycle through the different modes: H1 - Low Heat Mode H2 - Medium Heat H3 - High Heat...
Page 12
Children Lock Function It is effective in power on and standby mode. Press and hold the “ ” key and the “ ” key for 3 seconds to activate or deactivate the children lock function of the button. Alternatively, you can press the “ ”...
Page 13
Remote Control Operation • Point the remote control at the control panel of the heater and press the desired button. The remote control will wok at distances of up to 15 ft. and at an angle of 30 deg. to the right/left of the control panel. •...
Page 14
Batteries (included) • Slide to open the battery compartment cover. • Insert the batteries, and make sure that batteries are placed as shown in Fig. 1: • Slide the battery compartment cover into position as show in Fig. 2: Fig. 1 Fig.
Troubleshooting Operation of your appliance can lead to errors and malfunctions. The following table contains possible causes and notes for resolving an error message or malfunction. It is recommended to read the below table carefully when experiencing an error or malfunction.
Cleaning And Maintenance Always remove the plug from the receptacle and allow heater to cool. Wipe heater with a soft, damp cloth. Do not use detergents and abrasives. If the heater is not in use for an extended period of time, wind the cable around the holder and store it in a dry place.
SERVICE AND SUPPORT In the event of a warranty claim, questions, comments or if service is required for this product, please contact us at the following: Toll Free: 1-866-646-4332 Email us at: customerservice@supportuscenter.com Midea America Corp. Parsippany, NJ 07054 For your records, staple your sales receipt to this manual and record the following: DATE OF PURCHASE: PLACE OF PURCHASE: (STAPLE SALES RECEIPT HERE)
This one (1) year warranty is limited to the heating elements, motor, and electric control circuit board. In the event of malfunctions or failure of your Pelonis Product, simply deliver or send the heater, postage prepaid along with PROOF OF PURCHASE, within the warranty period of one (1) year, to PELONIS.PELONIS reserves the right to inspect the claimed defective part or parts...
Need help?
Do you have a question about the PSHO07JR4AGB and is the answer not in the manual?
Questions and answers