Table of Contents
Advertisement
Attaching and Removing the Dust
Cover
Attaching the Dust Cover
1
Align the dust cover's hinge clips (one on each side) with the
pins of the drive bezel.
•
The dust cover should be positioned so that the magnets
cover's back face the drive bezel.
*
This magnet does not affect the tape of the cartridge.
•
Holding the dust cover at an angle as shown in the figure below, set
the hinge clips on top of the bezel pins, positioning them so that
they bracket the pins.
22
*
on the
Advertisement
Table of Contents
