Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Spinfire Inferno
Summary of Contents for Spinfire Inferno
- Page 1 Inferno Stringing Machine Manual Installation and Operation...
-
Page 2: Table Of Contents
Table of Contents Description of Parts 1 TABLE OF CONTENTS.................1 2 DESCRIPTION OF PARTS..............1 3 FRAME MOUNTING AND TENSIONING THE STRING.......2 4 STRINGING THE FRAME ..............2 5 BASE CLAMP ADJUSTMENT…………………………….......3 6 PREPARATION OF STRINGING............3 7 CALIBRATING THE MACHINE……............4 1. Machine Base 8. -
Page 3: Frame Mounting And Tensioning The String
Frame mounting and tensioning the string Stringing the frame Step 1: To set the tension, turn the Step 1: Insert the angled frame knob until registered at the desired supports (12) into the appropriate poundage. For example, to set the slots located on the end of the side tension for 23 pounds, the tension support arms (9). -
Page 4: Base Clamp Adjustment
Preparation of Stringing Step 4: Keep rotating until the tensioning lever clicks out. This To clamp the string, squeeze the lever closed (do not locks the tension head to the close the lever further than the image shown below tension arm. Your string should be (left)). -
Page 5: Calibrating The Machine
Calibrating the Machine Calibrate the tension head when you find the stringing machine is not pulling Step 3: Use a 2mm Allen key to loosen the safety screw. To achieve a at the correct tension. To test your machine you need a Tension Calibration higher tension, turn the tension adjustment screw counter-clockwise by Scale.
Need help?
Do you have a question about the Inferno and is the answer not in the manual?
Questions and answers