Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FinTec LORA Robust
Summary of Contents for FinTec LORA Robust
- Page 1 Instructions for use Multi-fuelled sauna heater FinTec LORA Robust (800.920.030) FinTec LORA Banja (800.920.031) FinTec LORA Loko (800.920.034) FinTec LORA Solar (800.920.033) FinTec LORA Swing (800.920.032) FinTec LORA Loko MH (800.920.035)
-
Page 2: Table Of Contents
Procedure ............................14 Infusion water ........................... 15 Sauna stones ............................. 15 Maintenance ............................15 FinTec - Factory guarantee ........................16 Declaration of Conformity ........................17 Contact us .............................. 18 FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... -
Page 3: Introduction
Introduction With a FinTec wood-burning sauna heater, you have purchased a high-quality product that has been handcrafted in Germany. You can expect simple operation and a long service life from the sauna heater. For your own safety, you should read these instructions carefully, follow them and keep them in a safe place. -
Page 4: Safety Instructions
WARNING! The surface of the stove, like the stones, can become very hot and cause burns if touched. WARNING! Use an infusion ladle with a long handle. FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... -
Page 5: Firewood
There are big differences between the calorific values of the different types of wood. To achieve the calorific power of birch wood, for example, you need approx. 15 % less beech wood. FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... -
Page 6: Take A Sauna Safely Please
Follow the sauna supplier's instructions. Furthermore, a wood-burning stove needs oxygen for combustion. This air must also be able to flow in through the supply air opening. FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... -
Page 7: Dimensions & Safety Distances
Only when there are no more unpleasant odours should the heater be heated for the sauna bath. Dimensions & safety distances Figure 1: Dimensions and lateral safety distances FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... - Page 8 Heat protection plate Minimum distance between upper edge of roof and heat protection plate At least Height 72.3 cm Figure 2: Dimensions and safety distances to the ceiling FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011...
-
Page 9: Product Description
Automatically closing fresh air May be placed directly on Fire-locked door for supply at operating temperature flammable materials without greater security for efficient, ecological and safe additional insulation panels combustion FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... -
Page 10: Spring Hinge
The door hinge is screwed onto two spacer plates, one 1 mm and one 2 mm thick. The door can be removed by simply loosening the two fixing screws and removing one or both spacer plates as required. The door can then be reattached. FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... -
Page 11: Requirements For The Sauna Room
For efficient combustion and a healthy sauna climate, a sufficient air supply must be guaranteed. In addition, it must be noted that FinTec sauna heaters are always dependent on room air! In principle, a sauna room should have a 5 to 6-fold air exchange every hour. -
Page 12: Installing The Sauna Heater
Installing the sauna heater You have already clarified the compatibility of the sauna heater with the chimney with your responsible chimney sweep before purchasing. He will check compliance with the building regulations. Please refer to the table for the technical data that you and your chimney sweep require. Observe all European and national regulations as well as all local regulations. -
Page 13: Safety Distances
Chimney system FinTec sauna heaters can be connected to any commercially available chimney system. It does not matter whether the chimney is made of solid brick or a stainless steel outdoor chimney is used. However, the following basic requirements must be met: •... -
Page 14: Initial Commissioning
5. Approx. minutes after lighting, the wood should have burnt down as far as possible. Carefully open the stove door and add another 3 to 4 logs until the stove is half full of wood again. FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... -
Page 15: Infusion Water
Depending on use, sauna stones must be replaced from time to time. We recommend replacing the stones completely every 18 to 24 months. For commercial use, we recommend replacing the stones completely after 12 months at the latest. Only quality sauna stones from FinTec Sauna- und Wellnesstechnik GmbH should be used. -
Page 16: Fintec - Factory Guarantee
The proof of purchase must always be presented in order to claim guarantee services. The FinTec guarantee extends to the free repair of the appliance or the faulty parts. Entitlement to free replacement exists only for those parts that show defects in material and workmanship. All direct labour and material costs incurred to rectify this defect will be covered. -
Page 17: Declaration Of Conformity
The safety instructions in the installation and operating instructions supplied with the product must be observed. (Follow the safety information in the installation and operation instructions) FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011... -
Page 18: Contact Us
Manufacture and distribution by the company FinTec Sauna- und Wellnesstechnik GmbH Ottostraße 15 95231 Münchberg Germany Tel: +49 (0) 9251 / 8997850 Fax: +49 (0) 9251 / 8997851 eMail: kontakt@fintec.de Internet: http://www.fintec.de FinTec Sauna- und Wellnesstechnik GmbH | Sauna heater operating instructions | © 2011...
Need help?
Do you have a question about the LORA Robust and is the answer not in the manual?
Questions and answers