Master Spas H2Xercise Instructions And Assembly

SAFETY FIRST:
IMPORTANT: Not all exercises are suitable for every individual.
Before beginning any exercise program, consult your physician.
WARNING: Inspect bungees and connections before every use.
Loose or degraded parts can cause snapping and potential injury.
CAUTION: Exercising in water that exceeds 91° Fahrenheit (F) /
32.78° Celsius (C) increases the risk of hyperthermia, which could
cause serious injury or death.
H2Xercise™ fitness equipment is intended for adult exercise only
and is not a life saving device.
To maximize the life of your H2Xercise products:
• Avoid extended exposure to sunlight.
• Avoid contact with harsh chemicals.
• Rinse with fresh water after each use.
• Store in a warm, dry place.
ASSEMBLY INSTRUCTIONS:

Rowing Equipment
1
Connect one end of the short
resistance band to the oar.
Before You Begin:
• For your safety, never exercise in the water without qualified
supervision.
• Aquatic footwear should be worn during your workouts if
your swim spa does not have the optional Nonslip, Comfort
Floor System.
• Always inspect bungees before use and never use if unsafe
conditions are seen (damage, cracking, or deterioration).
• Stay properly hydrated during your workout. Drink water
before, during and after exercising.
• Monitor how you are feeling at all times. If at ANY time, you
experience pain, stop exercising immediately. If pain persists,
consult your physician.
• If you experience any signs of overexertion such as labored
breathing, dizziness, nausea, loss of coordination, heart rate
irregularities or chest tightness, stop exercising immediately
and consult your physician.
2
Connect the other end of the
resistance band to the stainless
steel anchor in swim spa.
3
Press stainless steel connector
into the anchor hole on swim
spa. You should hear a click
when the connector is seated
properly. Repeat for oar on
other side of swim spa.
Continues on next page