Download Print this page

Unity MARK 2.0 Installation Instructions

For ops-core amp

Download this manual

WARNING: Over-torquing fasteners can damage your mount and will not be covered by warranty.

Remove AMP™ Cradle Clip Assembly from OEM headband.

Remove the cradle clip by holding plastic stems and firmly

pulling away. Clip stems will release. Set cradle clip aside.

Remove plastic stem receptacles from swaged wires by

rotating them 90 degrees and sliding off wire form. This

process is important as to not damage parts.

Need help?

Do you have a question about the MARK 2.0 and is the answer not in the manual?

Page 1 Clip stems will release. Set cradle clip aside. Remove plastic stem receptacles from swaged wires by rotating them 90 degrees and sliding off wire form. This process is important as to not damage parts. ©Copyright 2020, UNITY Tactical. All Rights Reserved.
Page 2 WARNING: Over-torquing fasteners can damage your mount and will not be covered by warranty. Slide plastic stems onto MARK wire forms facing outward in same direction depicted in illustration. Rotate them back 90 degrees so they face inward and re-install the AMP™ Cradle Clip. ©Copyright 2020, UNITY Tactical. All Rights Reserved.
Page 3 Install 2x Nuts into the ARC™ Adapter as shown. Slide ARC™ Adapter assembly onto ARC™ rail. Using 10-32 x 5/16 Screws (shorter included screws), secure MARK 2.0 assembly to the backer. Lightly snug both screws before applying torque to either. DO NOT EXCEED 10 IN-LBS.
Page 4 Leave the Accessory Cover Plate in place. Using 10-32 x 7/16 Screws (Longer included screws), secure MARK 2.0 assembly to the rail. Lightly snug both screws before applying torque to either. DO NOT EXCEED 10 IN-LBS.
Page 5 WARNING: Over-torquing fasteners can damage your mount and will not be covered by warranty. M-LOK™ Rails The M-LOK™ MARK 2.0 Accessory Kit is sold separately. Install the M-LOK™ Nuts and 10-24 x 3/8 screws included in the MARK 2.0 M-LOK™ Accessory Kit through the MARK 2.0 body.