Panasonic PT-LB75VE Operating Instructions Manual page 52

Care and Replacement
5 )
with a Phillips-head screwdriver.
6 )
7 ) Press the POWER button and the projection starts.
If INITIAL START UP in the PROJECTOR SETUP menu is set to ON, the projector starts projecting when the
mains lead is connected to a mains socket. ( page 41)
8 )
the PROJECTOR SETUP menu.
9 ) Press the ENTER button to select the PROJECTOR SETUP menu and
10 )
The LAMP RUNTIME
Note
If any button other than the POWER button is pressed, the LAMP RUNTIME screen disappears and the lamp
runtime is not reset. (Repeat from step 8 again).
11 ) Press the POWER button.
After the lamp goes off, projection stops and the POWER button lights in red, then disconnect the mains
plug.
12 ) The lamp runtime is reset to "0".
E
52 - NGLISH
LAMP RUNTIME
LAMP RUNTIME RESET.
OK PRESS BUTTON
CANCEL PRESS ANY OTHER BUTTON