Related Manuals for Feider FRVC2
Summary of Contents for Feider FRVC2
- Page 1 ORIGINAL INSTRUCTIONS >EN ROBOT VACUUM MOP CLEANER 3 IN 1 FRVC2 INSTRUCTION MANUAL CAUTION: Read this manual before using this machine!
-
Page 2: Table Of Contents
CONTENTS 1. IMPORTANT SAFETY INFORMATION..................... 3 2. PRODUCT INTRODUCTION....................... 6 3. INSTALLATION............................7 4. OPERATING INSTRUCTIONS......................9 5. MAINTENANCE AND CLEAN......................11 6. NORMAL QUESTIONS........................17 7. TROUBLESHOOTING........................18 8. SPECIFICATIONS ..........................18 9. DISPOSAL............................19 10. DECLARATION OF CONFORMITY....................20 11. WARRANTY............................21 12. -
Page 3: Important Safety Information
1. IMPORTANT SAFETY INFORMATION This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. -
Page 4: User Cautions
appliance. 1.1 USER CAUTIONS The Smart Vacuum Cleaner is for indoor use only. Do not use the Smart Vacuum Cleaner outdoor, commercial or industrial environments. Before using the Smart Vacuum Cleaner, pick up objects like clothing, loose papers, pull cords for blinds or curtains, power cords and any fragile objects. -
Page 5: Battery Care & Charging
with exposed electrical outlets in the floor. Detachable supply unit. WARNING: For the purposes of recharging the battery, only use the detachable supply unit provided (Automatic dirt disposal C1) with this appliance. 1.2 BATTERY CARE & CHARGING Charge using a standard outlet only. This product may not be used with any type of power converter. -
Page 6: Product Introduction
This appliance contains batteries that are only replaceable by skilled persons. Only to charge the battery in this appliance. Do not recharge non-rechargeable batteries. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. -
Page 7: Installation
2.3 AUTOMATIC DIRT DISPOSAL 2.4 BASE ACCESSORIES LIST 3. INSTALLATION 1. Please clean up the wires, hard objects, sharp objects (such as iron nails, glass) and other debris scattered on the ground before starting, and remove the easy, fragile, valuable and potentially dangerous items. - Page 8 Prompt: During the first cleaning process, it is recommended to follow the host throughout the process to assist in dealing with some possible small problems, and the host can be cleaned smoothly in the future cleaning. If some areas do not need to be cleaned or may be stuck, you can set a forbidden area in the mobile APP to block the host from entering the above areas.
-
Page 9: Operating Instructions
Note: Sunlight exposure will interfere with the recharge signal, which may cause the host to be unable to return to the Self-Emptying Base, ensure that there is more than 0.5 meters on both sides of the Self-Emptying Base and more than 1.5 meters in front of the space, and the power cord hanging on the ground may be dragged by the host, causing the Self-Emptying Base to lose power. - Page 10 4.2 SWEEP/PAUSE After the boot is completed, short press the upper button of the main machine, or the mobile APP to start cleaning. Note: Robot vacuums cannot be used to sweep liquids. If the battery level is less than 15%, you will not be able to perform the cleaning task, please charge it before continuing cleaning.
-
Page 11: Maintenance And Clean
Reset WIFI At the same time, long press for 3 seconds, and the voice prompt “WIFl has been reset ” is heard. The white lights of the power button flash, and the robot enters the waiting state for connection. After the connection is completed, the white lights of the power button are steady on. Tips: Only WIFI networks in the 2.4Ghz band are support. - Page 12 Edge brush (Weekly cleaning recommended) 1. Flip the machine and use a Phillips screwdriver to screw out the side brush screws and pull out the side brush. 2. Clean the tangled hairs and dirt and put it back on, and tighten the screws. Note: It is recommended to replace the side brush every 3 months to ensure the cleaning effect.
- Page 13 3. Dry the water droplets after cleaning, dry the filter screen and dust box, and wait until it is completely dry before use. Note: Please rinse with clean water and do not add any detergent. Do not use brushes, fingers to clean the filter.
- Page 14 Clean Cleaning spot laser detection sensor (monthly cleaning recommended) Cleanup cliff sensor (monthly cleaning is recommended) Clean the main unit charging contacts (it is recommended to clean them once a month) Clean the signal transmission area and charging contacts of the Self-Emptying Base (it is recommended to clean it once a month)
-
Page 15: Daily Maintenance
5.2 DAILY MAINTENANCE Dust bag replacement When the device prompts that the dust bag is full, please replace the dust bag in time. Dust bags are consumables and can be purchased through officially designated channels. 1. Open the upper lid 2. - Page 16 4. Install a new dust bag 5. Close the lid of the barrel Clean the dust collection channel and filter port If the dust collection effect is not good after replacing the dust bag, it is recommended to unplug the power plug and reverse the device to check whether there is any foreign matter blocking in the dust tunnel.
-
Page 17: Normal Questions
Firmware upgrades Through the mobile phone APP, enter the firmware upgrade function, and after the new firmware is detected, Follow the prompts to upgrade, the firmware requires ≥30% power during the upgrade, it is recommended to place the device on the Self-Emptying Base for upgrade. Maintenance of the battery 1. -
Page 18: Troubleshooting
Please check if the crash barrier is stuck. maintain it. If the problems cannot be solved according to the above operation, please contact the after-sales service. 8. SPECIFICATIONS Product model FRVC2 Rated voltage 14.4 Vd.c. Rated power HOST Battery type... -
Page 19: Disposal
Frequency band(s) Wi-Fi: 2412 - 2472 MHz Maximum radio-frequency power Wi-Fi: 16.681 dBm Dimensions 330x330x83mm Standby mode 0.5 W Networked Standby mode 1.9 W Time taken to automatically reach 19 minutes networked standby 220-240V~, 50/60Hz Rated inputs Charging state: 0.2A Dirt disposal state: 3.5A Rated outputs 20Vd.c. -
Page 20: Declaration Of Conformity
SODILOG SAS 4 RUE CURIE, CS 91617 68016 COLMAR CEDEX FRANCE ROBOTIC VACUUM MOP CLEANER 3 IN 1 FRVC2 Serial number: 20250622736-20250624835 This declaration of conformity is issued under the sole responsibility of the manufacturer. The object of the declaration described above is in conformity with the relevant Union... -
Page 21: Warranty
11 . WARRANTY The manufacturer guarantees the product against defects in material and workmanship for a period of 5 years from the date of the original purchase. It can be extended by one year if the user subscribes to website of myswap. The warranty only applies if the product is for household use. The warranty does not cover breakdowns due to normal wear and tear. -
Page 22: Product Failure
1 2 . PRODUCT FAILURE WHAT TO DO IF MY MACHINE BREAKS DOWN? If you bought your product in a store: • Make sure that your machine is complete with all accessories supplied, and clean! If this is not the case, the repairer will refuse the machine. •... -
Page 23: Warranty Exclusions
1 3 . WARRANTY EXCLUSIONS THE WARRANTY DOES NOT COVER: • Start-up and setting up of the product. • Damage resulting from normal wear and tear of the product. • Damage resulting from improper use of the product. • Damage resulting from assembly or start-up not in accordance with the user manual. •... - Page 24 SODILOG SAS 4 RUE CURIE, CS 91617 68016 COLMAR CEDEX FRANCE Made in PRC...
Need help?
Do you have a question about the FRVC2 and is the answer not in the manual?
Questions and answers