Related Manuals for saro EB 15 PRO
Summary of Contents for saro EB 15 PRO
- Page 1 Operating Manual Ice Cube Machinel EB 15 PRO / EB 15 S PRO Item-No.: 325-1020 / 325-1023 325-1023 325-1020 EB 15 S PRO EB 15 PRO...
-
Page 2: Table Of Contents
Page 2 of 16 Table of Contents SCOPE OF DELIVERY ........................3 STANDARDS AND DIRECTIVES ...................... 3 TECHNICAL OVERVIEW ........................4 SYMBOL EXPLANATIONS ......................... 5 GENERAL INSTRUCTIONS ....................... 6 SAFETY INSTRUCTIONS ........................7 DEVICE INSTALLATION ........................8 ELECTRICAL CONNECTION ......................8 STRUCTURE AND COMPONENTS .................... -
Page 3: Scope Of Delivery
The ice cube maker is especially suitable for the fast production of a larger quantity of ice cubes. Please read the operating instructions carefully before using the appliance for the first time. We wish you lots of enjoyment with your new SARO product. SCOPE OF DELIVERY •... -
Page 4: Technical Overview
Page 4 of 16 TECHNICAL OVERVIEW Ice Cube Machine Model EB 15 PRO EB 15 S PRO Item-No. 325-1020 325-1023 Material (Housing) stainless steel; (Lid) plastic Color grey black On/Off switch Yes (on the rear) Power connection Ready to plug in with Schuko plug Ice cube quantity Approx. -
Page 5: Symbol Explanations
Page 5 of 16 SYMBOL EXPLANATIONS 05/2025 PL... -
Page 6: General Instructions
Page 6 of 16 GENERAL INSTRUCTIONS • Keep this operating manual readily accessible near the appliance. • The manufacturer/supplier cannot be held responsible for any damage resulting from failure to follow this manual. • Failure to follow this manual voids the safety guarantee of the appliance. •... -
Page 7: Safety Instructions
Page 7 of 16 SAFETY INSTRUCTIONS • Improper use or handling may lead to device malfunction and user injury. • This appliance is not suitable or intended for storing medicines or flammable, combustible, or explosive substances. Observe accident prevention regulations and general safety standards applicable to the place of use. •... -
Page 8: Device Installation
Page 8 of 16 DEVICE INSTALLATION Set up the unit in a dry and sufficiently ventilated room. Make sure that the unit is placed on a dry and non-slip surface. Place the back of the appliance at least 10 cm from the wall to ensure sufficient air circulation at all times. There should be at least 30 cm above the unit and 10 cm to each side. -
Page 9: Structure And Components
Page 9 of 16 STRUCTURE AND COMPONENTS INITIAL START-UP Before first use: Unpack the appliance, check that it is complete and set it up (see Setting up the appliance). Clean the appliance (see Cleaning). Connect the cleaned cooling unit (see unit connection) to a 230 V socket. 05/2025 PL... -
Page 10: Operation - Settings
Page 10 of 16 OPERATION – SETTINGS - Open the hinged lid and fill water into the water tank. For this operation, remove the Ice cube storage container. Fill the appliance with water only up to the mark. Place the storage container again - Close the hinged lid. -
Page 11: Cleaning
Page 11 of 16 CLEANING Wipe down or wipe out the outside and inside with a damp, soft cloth. You can use a light cleaning agent. Do not use abrasive, bleaching, corrosive or scratching cleaning agents/cleaning aids, as this could damage/scratch the surfaces. Clean the storage container, the water tray and the ice pusher daily. -
Page 12: Troubleshooting
Page 12 of 16 TROUBLESHOOTING Problem Cause and Solution No cooling Is the plug inserted? Is the socket working? Is the fuse blown? Power outage? Restore the power supply to the appliance. Unsatisfactory cooling Direct sunlight? Is there a heat source nearby? Poor ventilation? performance Does the lid close properly? Is the lid gasket deformed or damaged? Loud noises... -
Page 13: Wiring Diagram
Page 13 of 16 WIRING DIAGRAM 05/2025 PL... -
Page 14: Exploded View Drawing
Page 14 of 16 EXPLODED VIEW DRAWING EXPLODED VIEW DRAWING – LEGEND Complete door Komplette Tür Evaporator Verdampfer Water box Wasserwanne (325-5115) Micro switch Mikroschalter (325-5045) Blocking piece Hebel Inner Liner cover Abdeckung der Innenverkleidung Inner Liner Innenverkleidung Inner Liner insulation Innenisolierung Sheet Platte aus Blech... - Page 15 Page 15 of 16 Main control board Steuerplatine Turning motor Motor für Wasserschale (325-5047) Front panel Vorderseite Limit pole Anschlag für Wasserwanne Operation board Bedienplatine (325-5100) Fixing for operation board Fixierung für Bedienplatte Operation board sticker Bedienfolie (325-5105) Ice storage basket Eiskorb (325-5110) Drainig rack Ablaufblende...
-
Page 16: Packaging Disposal
Your local authority can provide information on the locations and opening hours of disposal sites. This is the only way to ensure that old appliances are disposed of and recycled correctly. Thank you! Made in P.R.C for: SARO Gastro-Products GmbH Sandbahn 6, 46446 Emmerich am Rhein, Germany Tel. +49 (0) 2822 9258-0...
Need help?
Do you have a question about the EB 15 PRO and is the answer not in the manual?
Questions and answers