Skoda OCTAVIA - 05-2005 Manual page 88

86 Seats and Stowage
Assigning remote control to the memory buttons
After storing the settings of the seat and exterior mirrors, you
have 10 seconds in order to assign the remote control to the
appropriate memory button.
– Withdraw the ignition key.
– Press the button for unlocking the vehicle ⇒ page 52. The
setting is stored with the memory button which you have
selected.
If you wish to be able to retrieve the settings which are stored in the
memory by also using the remote control, you have to assign the remote
control to a memory button in each case.
If you wish, you can obtain an additional key with radio remote control
from a Škoda dealer and then assign the radio remote control to another
memory button.
Note
•
If the remote control had previously been assigned to another memory
button, this setting is then erased by the new assignment.
•
If you assign the remote control to a memory button which has already
been assigned to a remote control, the old assignment is also replaced by
a new assignment in this case.
•
The assignment of the remote control to a memory button is retained,
however, after reassigning the seats and exterior mirrors.
Retrieving settings of the seat and mirrors
You can retrieve the stored settings either with the
memory buttons or with the remote control*.
Retrieving settings with memory buttons
– In order to retrieve the stored setting, you have two possibili-
ties:
– One-touch automatic memory: Briefly press the desired
A ⇒ page 85, fig.
memory button
B
mirror are moved automatically into the stored positions (this
applies only if the ignition is switched on and the speed is less
than 5 km/h).
– Memory keying: Press and hold the desired memory button
A
pressed long enough until the seat and the exterior mirror
B
are moved into the stored positions.
Retrieving settings with remote control
– If the driver door is closed and the ignition is switched off,
briefly press the unlock button of the remote control ⇒ page 52
and then open the driver door.
– The seat and exterior mirrors now move automatically into the
stored positions.
Retrieving setting of exterior mirror for reversing*
– Turn the rotary knob for the exterior mirror setting into the
⇒ page 80 before engaging the reverse gear.

position
62. The seat and exterior