Osborne 8702 How To Build

This beautiful pipe shelving kit will make a statement in any industrial style home. This easy-to-assemble
product can be constructed in multiple ways giving you the ability to make it your own unique piece.
These steps will show you how to use the pipe shelving kit to make a three-tiered shelf that can sit flat
against the wall or be positioned in a corner of the room.
What's Included in the Kit:
A. (4) Disk plates
B. (4) Support connectors
C. (2) Bolt heads
D. (6) Curved corner pipes
E. (4) T-Connector Pipes
F. (1) 12 3/8" Pipe
G. (2) 10 1/2" Pipes
H. (2) 4 7/8" Pipes
I. (4) 3 1/2" Pipes
J. (4) 2 1/8" Pipes
K. (6) 1 3/8" Pipes
L. (12) Screw anchors
M. (12) 1 5/16" screws
N. (2) 13 3/4" long wooden shelves
O. (1) 15 3/4" long wooden shelf
Additional Tools Required:
Note: The entire shelf can be assembled by hand twisting the parts together. The following tools are not
needed until the last step of mounting the shelf to the wall.
• Pencil
Installation instructions:
1. First, we must put together the bottom shelf.
o Materials: G x 1, D x 2, E x 1, K x 2, C x 1, B x 1, N x 1, I x 1, J x 1, A x 1.
o Take one of the 10 1/2" pipes (G) and attach a curved corner pipe (D)
by twisting it onto the left side of the pipe facing up. On the right
side, twist to attach a T-connector pipe (E) utilizing the middle hole.
o Take two 1 3/8" pipes (K) and attach a bolt head (C) to one, and
a support connector (B) to the other. Then, place them into the
pre-drilled holes on your 13 3/4" wooden shelf (N). The bottom threads will attach to
the piece you made in the previous step.
o Line up the D/G/E piece with the K pipes underneath the shelf.
Twist to tighten both sides.
o Complete the first wall attachment by screwing a 3 1/2" (I) pipe
to the bottom of the T-connector on the right side of the shelf.
On the other end of the I pipe, attach a curved corner pipe (D)
facing the wall. Then, connect a 2 1/8" pipe (J) with a disk plate (A) on the end. This will
mount to the wall later.
2. Next, we will build the middle shelf.
o Materials: H x 1, E x 2, F x 1, I x 2, D x 2, J x 2, A x 2, O x 1, K x 2, B x 2
o Attach a 4 7/8" pipe (H) to the top of the support connector.
Use a T-connecter (E) to attach a 12 3/8" pipe (F). Place another
T-connecter (E) on the opposite side utilizing the middle hole.
How to Build a 3-Tier Pipe Shelf (Part #8702)
• Power drill • Mallet or hammer