ENCHANTED FOREST Grand Empress Fir One Plug User Instructions

Grand Empress Fir One Plug / 1-2-Tree - LED Color-Changing 7.5ft Tree • Item #2878000
PARTS LISTING:
EACH PRE-LIT GRAND EMPRESS FIR 1-2-TREE Contains:
(1) BOTTOM TREE SECTION (A)
(1) MIDDLE TREE SECTION (B)
(1) TOP TREE SECTION (C)
(1) METAL TREE STAND
(1) 3-Way Coaxial Power Cord
(1) 1-Prong Power Supply TRANSFORMER
(1) In-Line Foot Controller
(1) Remote Control
1. Unpack:
Carefully remove the contents from the carton and keep the carton for future storage. Some sections of the tree
may be heavy and assistance may be required. Remove any outer foam wrapping from the tree and its branches.
2. Basic Assembly Steps:
Open the carton and take out all the contents. All contents that are listed in the Bill of
Material section on this page should be enclosed. Locate the metal tree stand and assemble
it by separating the legs of the stand to form an "X" shape. Insert each of the three screws
into the holes on the stand's middle section, being sure that screws do not extend so far as
to interfere with installation of the tree pole. Place tree stand in desired location.
Locate Tree Section "A" and insert Tree Section "A" into the tree stand. Make sure the pole
is firmly inserted into the stand, and then turn all three screws until contact is made with the
pole. If Section "A" is not sitting straight, then simply loosen the screws, adjust tree pole,
and retighten the screws.
USER INSTRUCTIONS