Page 1
Westlake Water Solutions Chlorinators are ANSI/NSF-Standard 61 Applications use 3500 NSF-Listed for pool and spa applications ONLY ANSI/NSF Standard 61 listed Westlake Water when Westlake Water Solutions Accu-Tab Blue Solutions Accu-Tab SI Tablets and limit no more or Blue SI Tablets for commercial pool than 15 mg/l of tablet addition (or 10mg/l applications are used.
Page 2
Installation – Suction return – Pool Applications The following installation instructions are for Figure 1 only. Other installations are similar and may require more or less equipment. (NOTE: Model 3500 CANNOT be installed in suction return applications.) Using the existing circulation pump – Pump must have vacuum on the suction side.
Page 3
Installation – Suction Return Figure 1. The following installation instructions are for Figure 1 only. Other installations are similar and may require more or less equipment. (NOTE: Model 3500 CANNOT be installed in suction return applications.) Installation – Pressure Return Installation –...
3. Remove the lid. (Be careful not to chemicals. inhale fumes.) To clean the chlorinator while installed: 4. Fill the chlorinator with Westlake Water 1. Isolate the chlorinator from the system by Solutions Accu-Tab® Tablets. closing both the return and supply valves.
Page 6
System; (ii) you, at your cost, promptly return the System or defective part to such location as may be specified by Westlake Water Solutions; and, (iii) only Westlake Water Solutions Accu-Tab® Blue SI calcium hypochlorite tablets are used in the System.
Need help?
Do you have a question about the 3000 Series and is the answer not in the manual?
Questions and answers