JLab Audio EPIC SPORT Manual

FIRST TIME SETUP: BLUETOOTH PAIRING

1. Turn on the Bluetooth in your device settings.
   
3. Select "JLab Epic Sport" in your device settings to connect.
   Light will slow blink blue when Bluetooth is paired.
   

RECURRING USE

ACCESSORIES

BUTTON FUNCTIONS

EQUALIZER MODES

Quick press both buttons for different EQ settings
(Epic Sport will cycle 3 EQ settings)

VOICE PROMPTS

"HELLO" = Power is ON.

"BATTERY FULL" = 100-75%

"BATTERY MEDIUM" = 75-25%

"LOW BATTERY" = Less than 25%

"READY TO PAIR" JLab Epic Sport earbuds are ready to connect to your Bluetooth device.

"YOU'RE CONNECTED" JLab Epic Sport is connected to your Bluetooth device and ready for use.

"GOODBYE" = Power turning OFF.

CHARGING

1. Place the JLab Epic Sport control box in the magnetic charging station and plug in the USB to a computer or USB output device to charge.
   
2. Light will turn solid red when charging and turn blue when fully charged.
   

FITTING

CABLE CLIP USE

1. Attach optional cable holder to tighten or loosen the cable during use.
   
2. Insert the optional cable clip to the back of the cable holder.
   
3. Open the cable clip and attach to apparel.
   

CONNECTION TROUBLESHOOTING

I DO NOT SEE JLAB EPIC SPORT IN MY DEVICE

1. Turn Bluetooth off and then back on in device settings.
   
2. If you still do not see JLab Epic Sport, repeat FIRST TIME SETUP: BLUETOOTH PAIRING directions.
   

JLAB EPIC SPORT DOES NOT RECONNECT TO MY DEVICE AFTER POWERING ON

1. In device settings, forget the JLab Epic Sport.
   
2. Turn Bluetooth off then back on in device settings.
   
3. Repeat FIRST TIME SETUP: BLUETOOTH PAIRING directions.
   

BLUETOOTH IS CONNECTING TO AN UNWANTED DEVICE

Note: The JLab Epic Sport can remember up to 8 devices. It will try to auto-connect to last device used.

If you have more than one device that was connected to JLab Epic Sport, turn OFF Bluetooth on unwanted devices and turn ON Bluetooth on chosen device.

WARM-UP YOUR HEADPHONES

Optional: Burn-in is the process for exercising new audio equipment. We recommend 40 hours of burn-in time for most headphones to reach optimal performance. The main purpose of the process is to loosen the diaphragm of a newly crafted headphone and to stress the headphone driver. Normal, everyday use can also burn-in the headphones though JLab's proprietary burn-in provides an ideal mix of sounds and frequency sweeps to achieve this.

Burn-in your audio equipment with the JLab Audio app available on the App Store and Google Play.
Or access the burn-in method at: jlabaudio.com/burnin

• Avoid getting moisture or liquids into the tip of the earbuds or charging port.
• Avoid extreme heat, cold, and humidity.
• Avoid dropping or crushing the earbuds, stressing the cable by rapid pulling or extreme force, or bending the cable at a sharp angle.
• Wax may build up in the earbud tips, lowering the sound quality. Carefully remove the wax with a cotton swab or other small tool to improve the sound quality.
• If you experience discomfort or pain, try lowering the volume or discontinuing use temporarily.
• If you experience regular discomfort while using this product, discontinue use and consult your physician.
• We recommend you treat your earbuds as you would a nice pair of sunglasses and keep them in safe location when not in use.

JLABAUDIO.COM