Related Manuals for Truper PRO SOPLI-40A
Summary of Contents for Truper PRO SOPLI-40A
- Page 1 Manual 40 V Cordless blower Applies for: Code Model 103303 SOPLI-40A 103555 SOPLI-40AS SOPLI-40A CAUTION Read this manual thoroughly before using the tool.
-
Page 2: Table Of Contents
Authorized Service Center Warranty policy Use and care recommendations Use ONLY the provided charger or the one suggested by TRUPER to charge the battery. Follow the battery GUIDELINES and charging INSTRUCTIONS (page 6). Keep the tool and charger ventilation slots CLEAN. -
Page 3: Technical Data
The construction class of the charger is: Reinforced insulation WARNING If the power cable is damaged, it must be replaced by the manufacturer or a TRUPER Service Center to prevent any risk of electric shock or significant accident. The electrical insulation of this tool is compromised by splashes or spillage of liquids during its operation. -
Page 4: General Safety Warnings For Power Tools
Be alert, watch what you are doing, and use common sense Service when handling an electrical tool. Do not use it if you are tired Repair the tool at an Authorized TRUPER Service Center or under the influence of drugs, alcohol, or medication. using only identical replacement parts. -
Page 5: Safety Warnings
CAUTION • Service and repair of the tool should only be otherwise, do not use the tool. performed by an Authorized TRUPER Service Center. • Use ear protection when performing tasks that generate noise levels above 85 dB Assembly recommendations WARNING •... -
Page 6: Battery Safety Warnings
Battery safety warnings DANGER WARNING General safety warnings for the battery charger ENGLISH... -
Page 7: Parts
Parts Variable speed Handle trigger Turbo button Motor housing cover Tube release button Fan cover Nozzles / Blowing tubes Dual charger* (Model: CARD-20A) Battery release button Batteries* (*These accessories are not included with model SOPLI-40AS) -
Page 8: Preparation
Preparation Charging the batteries 1. Plug the charger into a 127 V~ outlet. 2. Slide the batteries into the charger as shown in the image. The green light should start blinking, indicating that charging has begun. • When the batteries are fully charged, the green light will remain on until you remove the fully charged battery from the charger. -
Page 9: Assembly
Assembly Nozzle extensions • To attach the nozzle extensions, align the internal slots of the female connections (B) with the stops on the male connections (C). Connect and twist to secure the connection. • Install one or two nozzle extensions as needed. Start up On / Off •... -
Page 10: Operation
• Regularly inspect all mounting screws and Tool servicing should only be done at an Authorized ensure they are properly tightened. If any screws TRUPER Service Center. Service and maintenance are loose, tighten them immediately. performed by unqualified individuals can be •... -
Page 11: Troubleshooting
The charger becomes • This heating is normal, the result of voltage hot during charging. regulation. If problems persist despite performing the recommended corrective actions, contact a TRUPER Authorized Service Center. ENGLISH... -
Page 12: Notes
Notes ENGLISH... -
Page 13: Authorized Service Center
In the event of any problem contacting an Authorized Truper Service Center, please see our webpage WWW.TRUPER.COM to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-873 to get information about the nearest service center. -
Page 14: Warranty Policy
It includes the costs of transportation of the product that derive from its fulfillment of its service network. . Phone number 800-018-7873. Made in Vietnam. Imported by TRUPER, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.
Need help?
Do you have a question about the PRO SOPLI-40A and is the answer not in the manual?
Questions and answers