Marshall Amplification MG15FX Quick Start Manual

MG15FX &
MG30FX
QUICK START GUIDE
DOWNLOAD THE FULL MANUAL AT
Informazioni disponibili in Lingua italiana. Visita marshall.com per scaricare il manuale completo in Italiano.
Product dimensions (height x width x depth):
MG30FX 420mm × 480mm × 225mm
MG50FX 505mm × 520mm × 280mm
WARNING! SAFETY INSTRUCTIONS
PLEASE READ THIS MANUAL CAREFULLY BEFORE PLUGGING IN.
FOLLOW ALL INSTRUCTIONS AND HEED ALL WARNINGS.
Warning: Please refer to full
details in separate Important
Safety Instructions CATS-90009.
Warning: before going any
further, make sure that your amp
is compatible with your mains
electricity supply. If you have
any doubt, please seek help from
a qualified technician – your
Marshall dealer can help you
with this.
MAINS INPUT & FUSE
The specific mains input voltage
rating that your amp has been
manufactured for is indicated on
the rear panel of the amp.
Never attempt to bypass the fuse
or fit one of the incorrect value
or type.
IMPORTANT SET UP INFORMATION
1. Ensure that the power switch is
set to the off position.
2. Connect the supplied mains
Whilst the information contained herein is correct at the time of publication, due to its policy of constant improvement and development,
Marshall Amplification Plc, Denbigh Road, Bletchley, Milton Keynes, MK1 1DQ, England. T: +44 (0) 1908 375411. Registered in England. Registered Number: 805676.
Unit weight 10.8kg
Unit weight 16.6kg
(power) lead into an electricity
outlet.
3. Ensure that any master volume
and/or output level controls on
the front panel are set to zero.
4. Plug your guitar into the input
jack socket on the front panel.
5. Turn the front panel power
switch on.
6. Turn the volume up to your
preferred level and you're
ready to play.
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is
switched off, unplugged from
the mains electricity supply and
all removable cables have been
disconnected from your equipment
before attempting to move it.
FCC COMPLIANCE STATEMENT
This device complies with part
15 of the FCC Rules. Operation
is subject to the following two
conditions:
1. This device may not cause
Marshall Amplification Plc reserves the right to alter specifications without prior notice.
harmful interference, and
2. This device must accept any
interference received, including
interference that may cause
undesired operation.
This equipment has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC
rules. These limits are designed
to provide reasonable protection
against harmful interference in a
residential installation.
This equipment generates, uses
and can radiate radio frequency
energy and, if not installed
and used in accordance with
the instructions, may cause
harmful interference to radio
communications.
However, there is no guarantee
that interference will not occur
in a particular installation. If
this equipment does cause
harmful interference to radio or
ENGLISH
M3311.419
CATS-90025-02
television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation
between the equipment and the
receiver.
• Connect the equipment into
an outlet on a circuit different
from that to which the receiver
is connected.
• Consult the dealer or an
experienced radio/TV
technician for help.
Caution: Any changes or
modifications not expressly
approved by the party
responsible for compliance could
void the users authority to operate
the equipment.
This device complies with CAN
ICES-3(B)/NMB-3(B)