Salter 1066 Manual

BATTERIES

1 x CR2032. Ensure +/- terminals are the correct way round. Remove isolator tab before first use.

TO SWITCH ON

1. Place bowl on scale before switching on.
2. Press and releaseON/ZERO button. 8888 appears on display.
3. Wait until display shows0.

TO CONVERT WEIGHT UNITS

Press g-oz button to convert between metric and imperial units, at any time during weighing.

TO ADD & WEIGH

To weigh several different ingredients in one bowl, press ON/ZERO to reset the display between each ingredient.

AUTO SWITCH OFF

Auto switch-off occurs if display shows 0 for 1 minute or shows the same weight reading for 3 minutes.

MANUAL SWITCH OFF

Press and hold ON/ZERO button (approx. 3 seconds) until the display is blank.

WARNING INDICATORS

Lo Replace battery.
Err Weight overload
---- Press ON/ZERO

CLEANING & CARE

• If the scale is not to being used for a long period, remove the battery. Always remove flat batteries immediately.
• C lean the scale with a slightly damp cloth. DO NOT immerse the scale in water or use chemical/abrasive cleaning agents.
• A ll plastic parts should be cleaned immediately after contact with fats, spices, vinegar and strongly flavoured/coloured foods. Avoid contact with acids such as citrus juices.

Contact:
HoMedics Australia Pty Ltd, 14 Kingsley Close, Rowville,
VIC 3178 | (03) 8756 6500
Phoenix Distribution NZ Ltd, Unit 1/9 Orbit Drive, Albany, Auckland, New Zealand 0632 (09) 475 0007