Advertisement
BACKUP POWER KIT
INSTRUCTION AND OPERATING MANUAL
IMPORTANT!
READ ALL INSTRUCTIONS CONTAINED IN THIS MANUAL
BEFORE USING THIS PRODUCT.
Save these instructions for future reference. Failure to read and follow
the warnings and instructions within this instruction manual could result
in property damage, serious injury or death.
Mainlinecollection.com
Specifications
AMP Rating
Temperature Rating
Discharge
MODEL MLFS22743
MODEL MLFS22738
FloodStop® PumpTech Support: 1-833-786-7779
4.7 Amps
42°F to 95°F
1-1/2" NPT
Advertisement
Table of Contents
Related Manuals for MAINLINE FLOODSTOP MLFS22743
Summary of Contents for MAINLINE FLOODSTOP MLFS22743
- Page 1 BACKUP POWER KIT INSTRUCTION AND OPERATING MANUAL Specifications AMP Rating 4.7 Amps Temperature Rating 42°F to 95°F Discharge 1-1/2” NPT MODEL MLFS22743 MODEL MLFS22738 IMPORTANT! READ ALL INSTRUCTIONS CONTAINED IN THIS MANUAL BEFORE USING THIS PRODUCT. Save these instructions for future reference. Failure to read and follow the warnings and instructions within this instruction manual could result in property damage, serious injury or death.
- Page 2 SAFETY FIRST! This instruction manual contains very important information for you to know and understand. This information is provided for your safety and to help prevent equipment problems from occurring. Please observe all safety information labeled danger, warning, caution, and notice. WARNING INDICATES A POTENTIALLY HAZARDOUS SITUATION WARNING WHICH, IF NOT AVOIDED, COULD RESULT IN DEATH, SERIOUS...
- Page 3 PUMP PERFORMANCE GPH of Water @ Total Feet of Lift Max. MODEL Lift 0 ft. 5 ft. 10 ft. 15 ft. 20 ft. 25 ft. MLFS22208 MLFS22212 4300 3900 3500 3100 2500 1700 30 ft. MLFS22213 MLFS22209 MLFS22214 3800 3400 3000 2500 1800...
- Page 4 PUMP INSTALLATION 1. Set the pump on a solid, level surface in the bottom of the sump pit. If necessary, use a pump stand to provide a solid base. Avoid placing the pump on loose gravel, earth or sand. 2. Install discharge plumbing according to state and local codes. It is highly recommended that rigid PVC is used for the discharge line.
- Page 5 PUMP CARE AND CLEAN CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns, unplug the pump and allow time for it to cool after periods of extended use. DO NOT •...
-
Page 6: Pump Troubleshooting
PUMP TROUBLESHOOTING CAUTION INDICATES A POTENTIALLY HAZARDOUS SITUATION WARNING WHICH, IF NOT AVOIDED, MAY RESULT IN MINOR INJURY OR PROPERTY DAMAGE. PROBLEM POTENTIAL CAUSE POSSIBLE SOLUTION Pump Will Not Run 1. Blown fuse, tripped breaker or 1. Check all electrical connections. tripped GFCI Check for blown fuses, tripped GFCI 2. -
Page 7: Battery General Information
BATTERY GENERAL INFORMATION To ensure safe and reliable operation, please carefully read this service and installation manual in its entirety before installing and/or using this product. Reasonable care and safe methods in according with sound plumbing practices should be strictly adhered to. Before installation, refer to and understand all relevant local plumbing and electrical codes. -
Page 8: Battery Operation
BATTERY OPERATION When 120VAC household power is available to the Primary Sump Pump Backup Power System, household power is directly routed through to both of the outlet receptacles. When the unit is powered ON (the “Power” indicator LED will be BLUE), the unit will charge the connected 12VDC Deep Cycle Battery if needed. -
Page 9: Battery Installation
BATTERY INSTALLATION 1. Ensure the Backup Power System is powered off and disconnected from both AC and DC power. 2. Remove the Pre-Charge Kit from the positive (RED) battery lead ring. Open the Pre-Charge Kit and wrap one of the resistor wires around the positive (RED) battery lead ring. 3. -
Page 10: Battery Troubleshooting
BATTERY TROUBLESHOOTING WARNING Always disconnect the power unit from power sources before handling. This guide is designed to help identify reasons for potential operating problems. It is not a service guide. Dismantling of the Primary Sump Pump Backup Power System voids warranty. Servicing of power unit should be referred to FloodStop. - Page 11 TERMS AND CONDITIONS OF SALE Orders for this product are expressly made conditional on buyer’s assent to company’s terms and conditions of sale, which can be found by scanning the QR code below, or are available upon request by mail. Any terms and conditions in any of buyer’s documents that are inconsistent with or add to seller’s terms and conditions of sale are hereby rejected and are not binding upon company.
- Page 12 Fax: 901-853-5008 www.ipscorp.com Warranty See warranty information for more details. All dimensions listed are nominal. MAINLINE ® reserves the right to make product and material changes at any time without notice. 83613-01 Contact your sales representative for more information or visit our website at mainlinecollection.com...
Need help?
Do you have a question about the FLOODSTOP MLFS22743 and is the answer not in the manual?
Questions and answers