Download Print this page
Jumper T14 Manual
Hide thumbs Also See for T14:

Advertisement

Quick Links

Simple yet versatile. Tailor-made for FPV.
The
most
compact,
full featured ELRS
GEMINI
radio
The
most
compact,
full featured ELRS
GEMINI
radio

Advertisement

loading
Need help?

Need help?

Do you have a question about the T14 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Jumper T14

  • Page 1 Simple yet versatile. Tailor-made for FPV. most compact, full featured ELRS GEMINI radio most compact, full featured ELRS GEMINI radio...
  • Page 2 Thank you for purchasing the Jumper T14 radio system. Please read this instruction manual carefully before use to ensure correct and safe use. Due to version upgrades,there have been changes. The information contained in this manual is subject to change without notice.
  • Page 3 EdgeTX is an experimental firmware. No warranty or implied warranty is given as to the quality and reliability of this firmware. The RC model can cause serious injury or even death if not handled properly. If you choose to use EdgeTX firmware, you will be solely responsible for your model. The author of EdgeTX is not responsible for any injury or damage caused by the use of the EdgeTX firmware.
  • Page 5 2.42”OLED Screen Note: In order to prevent T14 from entering DFU mode during charging and to reduce the probability of firmware loss during charging, T14 is equipped with a separate Boot0 button. To enter DFU mode, shut down the radio, press and...
  • Page 16 T14 is set to MODE2 (the left-hand throttle) out of the factory. The user can change the mode by himself by reversing the gimbals, and then long-press the "sys" key to enter the "RADIO SETUP" page, turn to the bottom to "mode" and select the corresponding mode...
  • Page 17 Attn: When the battery is installed in the T14 for the first time, please keep the battery voltage consistent to reduce the burden on the voltage balance circuit.
  • Page 20: Locking Screw

    Adjustment instructions for gimbal stick height 1, Remove the gimbal stick ends locking screw. 2,Turning the gimbal stick ends clockwise will shorten the gimbal stick length. Turning it counterclockwise will lengthen the gimbal stick. 3,After adjusting the gimbal stick length, hold the gimbal stick end with your hand and tighten the locking screw. Warning: The gimbal of the radio controller is a precision device.
  • Page 21 FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications.