Campania International Sphere FT-159 M Series Assembly Instructions

Fountain Components
Image Item Description
M-Series Sphere
Fountain Water
M-Series Sphere
Fountain Base
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Component
Quantity
Item #
FT-159A 1
Feature
FT-159C 1
Fountain Set-Up:
SHOP NOW
FT-159 M-Series Sphere Fountain
Assembly Instructions
Fountain Information:
• This fountain holds approximately 1/2 gallon of water.
• A fountain cover is not available for this fountain.
• No refill device or submersible lights are suggested for this fountain.
Pump Information:
WP450LV - 120 GPH Low Voltage Pump (16 ft. cord length)
Tools Required:
Bubble Level
Screwdriver
Scissors
Pump Kit Parts List
Image
PK120-LV pump with Transformer
Approx. 2" length of 5/8" clear tubing
Approx. 2" length of 1/2" clear tubing
MADE IN USA
Component
#7 Stopper
2" length of PermaGum Putty
Approx. 4" length of 1/2" black
non-kink tubing
Adhesive Dots
Hose Clamps
Proudly
Quantity
1
1
1
1
1
1
4
1
rev 02/22/2024