Download Print this page

ANBOO A029 Instruction Manual

In-ground basketball stand

Advertisement

Quick Links

ANBOO
Owner must ensure that all players know and follow these rules for safe operation of the system.
To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box
and inside all packing material for parts and/or additional instruction material. Before beginning assembly, read the
instructions and identify parts using the hardware identifier and parts list in this document. Proper and complete
assembly,use,and supervision are essential for proper operation and to reduce the risk of accident or injury. A high
probability of serious injury exists if this system is not installed,maintained,and operated properly.
·If using a ladder during assembly, use extreme caution.
·Two(2) capable adults are recommended for this operation.
·Check base regularly for leakage. Slow leaks could cause system to tip over unexpectedly.
·Seat the pole sections properly(if applicable). Failure to do so could allow the pole sections to separate during play and/
or transport of the system.
·Climate, corrosion,or misuse could result in system failure
·Minimum operational height is 66"(1.98 m)to the bottom of backboard.
·This equipment is intended for home recreational use only and NOT excessive competitive play*Read and understand
the warning label affixed to pole.
·The life of your basketball pole depends on many conditions. The climate placement of the pole location of the pole
exposure to corrosives such as pesticides, herbicides or salts are all important.
·Adult supervision is recommended when adjusting height.
Notice to assemblers:
All the basketball systems. including those used for displays,must be assembled and ballasted according to instructions.
Failure to follow instructions could result in serious injury.
Please read all warnings and cautions before assembly It is recommended to supervise children as they play with this
product. This product is to be assembled by 2 adults only!
We appreciate your purchasing one of our many fine products. We are assure that you will be very satisfied with your
selection.
IN-GROUND BASKETBALL STAND A029
SAFETY INSTRUCYIONS
1
INSTRUCTION MANUAL

Advertisement

loading
Need help?

Need help?

Do you have a question about the A029 and is the answer not in the manual?

Questions and answers

Summary of Contents for ANBOO A029

  • Page 1 ANBOO INSTRUCTION MANUAL IN-GROUND BASKETBALL STAND A029 SAFETY INSTRUCYIONS Owner must ensure that all players know and follow these rules for safe operation of the system. To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box and inside all packing material for parts and/or additional instruction material.
  • Page 2 Please confirm that the following accessories are complete after opening the package.
  • Page 3 Installation Steps: 1.Install the main rod (2) on top of the embedded part. When installing, pay attention to the front and rear orientation of the main rod (2). Adjust the verticality of the main rod. After confirming that it is correct, tighten the fastening nut.
  • Page 4 2.Put part (13) on the main rod (2).Install the part (8&9) behind the main rod (2) by bolt (C). The lifting rod (3) is connected to the part (8) by bolt (D). Install the hand crank (4) at the lower end of the lifting rod (3).
  • Page 5 3.The bracket (7) and bracket (11) are mounted in two holes in the upper part of the main rod (2) by two bolts (B). When installing, install according to the position of the picture below, and pay attention to the front and rear orientation of the bracket (11). Connect the upper end hole position of the lifting rod (3) with the hole position at the rear end of the bracket (11) by bolt (A).
  • Page 6 4. Connect the bracket (7) to the basketball board (10) by two bolts (E). The bracket (11) is connected to the part (12) by one remaining bolt (B). Part (12) is connected to the basketball board (10) and the basketball hoop on the front of the basketball board by four bolts (F).
  • Page 7 5.Adjust the height of the basketball hoop by shaking the hand crank (4). After hanging the basketball net, adjust the hoop to the appropriate height. Install the shield (1) and the bottom sheath (5). All installation steps are now complete.