1. Manuals
  2. Brands
  3. Feighner Manuals
  4. Lifting Systems
  5. Easy Riser
  6. Manual

Feighner Easy Riser Manual

2,500/4,000 lb vertical cable feighner lift
Hide thumbs

Advertisement

Table of Contents

2,500/4,000 LB Easy Riser
Vertical Cable Feighner Lift
CAUTION - PUT SAFETY FIRST
1.Before attempting to install or operate this lift, study and fully understand the proper operating
procedures and safety precautions outlined in this owner's manual.
2.Never exceed the recommended weight capacity of your lift. The lifted weight will include hull,
engine, fuel, battery, and added accessories or gear. Weigh your fully loaded boat at a certified
scale to be absolutely sure of the total weight.
3.Do not allow anyone on, in, or under the lift while operating.
4.NOT COMPLYING WITH THE PROCEDURES AND PRECAUTIONS OUTLINED IN THIS
MANUAL WILL INVALIDATE THE WARRANTY AND MAY RESULT IN PERSONAL INJURY OR
DEA TH .
5.If you have any questions about assembly, installation, operation or suitability of this product,
contact an authorized dealer or The Feighner Co. directly at 1-517-541-0900.
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Easy Riser and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Feighner Easy Riser

Summary of Contents for Feighner Easy Riser

  • Page 1 MANUAL WILL INVALIDATE THE WARRANTY AND MAY RESULT IN PERSONAL INJURY OR DEA TH . 5.If you have any questions about assembly, installation, operation or suitability of this product, contact an authorized dealer or The Feighner Co. directly at 1-517-541-0900. Page 1...
  • Page 2 Vertical Boat Lift Hardware 24 – 3/8 x 4 ¼ HHC SS 4 – 3/8 x 3 ½ HHC SS 8 – 3/8 x 1 ¼ HHC SS 36 – 3/8 Nylon Insert Lock nut Brass 2 – ½ x 4 ½ HHC SS 7 – ½ Nylon Insert Lock nut Brass 9 –...

  • Page 3: Warnings And Safety

    Introduction Feighner vertical lifts will lift your boat up and out of the water for dockside storage. These lifts are designed to rest on a stable lake bottom. This lift performs will in low water conditions, fluctuating water depths up to four feet or when your boat requires mooring high out of the water.
  • Page 4 Assembly Instructions Your safety is the most important issue related to this product. Wear protective gloves, clothing and eyewear when assembling and installing the lift. Do not assemble, install or use this product if items are missing or damaged. Fully read and understand each step before proceeding with that step. Keep all bolts loose at first.
  • Page 5 Step 3 Attach one Bottom Beam to rear of both V Lift Sides. Using 3/8 x 4-1/4 HHC bolts with 3/8 Nylon Brass Nut *NOTE: Bolt only five of the six holes at each corner at this time. The remaining hole will be used in a later step.
  • Page 6 Step 6 Side racks. Next grab side rack Right/A and lay it on the frame as picture. Place end with cable loop into position. Secure cable loop using the open hole in the frame. (V Side) Slide in a 3/8 x 4 ¼...
  • Page 7 Step 8 Grab the Front/Winch rack. These will have the rollers welded to them and labeled. Place end with cable loop into position. Secure cable loop using the open hole in the frame. Slide in a 3/8 x 4/ ¼ HH SS and 3/8 Brass nut. Attach the winch rack to Left/B and Right/A rack.
  • Page 8 Caution Failure to attach cables, I-bolts, washers and lock nuts correctly could result in a severe crushing, cutting or pinching injury. Severe damage to lift or boat could also occur. Step 10 Remove Winch cover by unscrewing two screws Facing the front of the winch, the attachment bolts are added on the left side as shown.

  • Page 9: Installation Instructions

    Do not under any circumstances, endanger yourself or risk damage to your lift or boat when installing. • Situations will widely vary between installation sites. Feighner Company. Recommends that your dealer or other trained boat lift installer train you and perform the initial installation.
  • Page 10 If they are not, adjust the legs accordingly. Note: If the lift legs will extend 3 feet or more, Feighner Boat Lift and Docks recommends deep water braces to stabilize and strengthen the lift. Ask your dealer for more information.
  • Page 11 Turn wheel in direction of arrow (clockwise) to raise lift. Turning wheel and wrapping cable in wrong direction may cause fast spin down of wheel. WARNING Stay clear of lifts (facing wheel) while operating. Do not allow anyone on, in or under lift. A cable or lift part failure can cause a sudden drop of boat, resulting in a crushing or falling injury or death! CAUTION...

  • Page 12: Monthly Checks

    5. Check and lubricate pulleys to ensure that they are turning freely. 6. Check Eye-Bolts to make sure they are not working themselves loose. Feighner dealers usually offer service visits. Please contact them if you are unable or unwilling to perform maintenance or service to lift.

Table of Contents