Table of Contents
Advertisement
Quick Links
hydro Max II Assembly Manual
Assembly Instructions
Hydro-Max II series, 2000# through 12,000# units.
CAUTION - PUT SAFETY FIRST
1. Before attempting to install or operate this hoist, study and fully
understand the proper operating procedures and safety precautions outlined
in this owner's manual.
2. Never exceed the recommended weight capacity of your lift. The lifted
weight will include hull, engine, fuel, battery, and added accessories
or gear. Weigh your fully loaded boat at a certified scale to be
absolutely sure of the total weight.
3. Do not allow anyone on, in or under the lift while operating.
4. NOT COMPLYING WITH THE PROCEDURES AND PRECAUTIONS
OUTLINED IN THIS MANUAL WILL INVALIDATE THE WARRANTY
AND MAY RESULT IN PERSONAL INJURY OR DEATH.
5. If you have any questions about assembly, installation, operation or
suitability of this product, contact your authorized dealer.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Feighner Hydro Max II Series
Summary of Contents for Feighner Hydro Max II Series
- Page 1 hydro Max II Assembly Manual Assembly Instructions Hydro-Max II series, 2000# through 12,000# units. CAUTION - PUT SAFETY FIRST 1. Before attempting to install or operate this hoist, study and fully understand the proper operating procedures and safety precautions outlined in this owner's manual.
- Page 2 Assembly Instructions – Hydro-Max II, 2000# through 12,000# units. Contents: 1. 1 Main Lift Assembly. 2. 1 Front Beam, 1 Rear Beam, (interchangeable). 3. 4 Leg pockets, with 3’ legs attached. (short- standard / long - canopy) 4. 1 Black Box, (or upgraded White Fiberglass box) 5.
- Page 3 Assembly: 1. Assemble lift on smooth level surface, free from obstructions. Unpack all components at this time, except for the hydraulic hoses. Leave this item wrapped for now to avoid contaminants from entering the fluid system. 2. Assemble Rear Beam: 1 Rear Beam, 2 Rear Plates, (8) bolts 3/8 x 3 1/2” long and (8) nuts. Center Beam, left to right, with Main Lift Assembly.
- Page 4 Installation: Tools required: 1. ¾” box wrench Instructions: Survey the installation area for rocks, stumps or other obstructions, remove debris or relocate lift site. 1. Inspect boat hull for any protrusions, such as turn fins, speedometer pickups, live well inlets, cruise control pickups, etc.
- Page 5 9. Adjust Flow Control Valve (located on the pump next to the top screw connector). A flow control valve is used to regulate the decent (downward movement) of the lift. To open and the boat lowers to fast causing stress on the frame during abrupt stops. To shut, and undue stress on the battery is encountered.
- Page 6 ¾ full. The majority of your fluid is in the reservoir at this time. b) Should you have a spill, don’t worry, Hydro Max II series lifts are filled with biodegradable hydraulic fluid. Contact your authorized dealer for replacement fluid.
Need help?
Do you have a question about the Hydro Max II Series and is the answer not in the manual?
Questions and answers
My lift went up but won't go down
How do I pair the remote with the lift?