Visioneer OneTouch 9520 User Manual page 78

To remove a selection box, select it by
clicking on it or clicking its tab, then
click the Remove button.
8. You can also adjust the image quality and select new TWAIN
Tip: For 35mm slides or negatives, set the resolution to 1200 dpi or
better. Visioneer recommends using a resolution of 2400 dpi. Refer to
"Adjusting the Resolution" on page 55 for steps to set the resolution.
9. Click Scan when you are satisfied with the image.
10. When you're finished scanning the slides or negatives, click Done
11. The scanned image appears in the scanning application, where you
Remove an image from scanning—You may want to only scan
■
one negative in a filmstrip. In that case, you remove selection
boxes around the other images. To remove a selection box, select
it by either clicking in it or clicking its tab on the Scan Info box,
then click the Remove button on the Scan Info box.
settings. See "Adjusting the Image on the Advanced Interface" on
page 53 for details about adjusting settings.
to close the Advanced Interface.
can then modify the image.
S 35 S
CANNING MM LIDES AND
N 71
EGATIVES