Assembly Instructions
(Please refer to the actual size.)
Step 1
First, separate the base into two parts: the decorative cover and the chair leg base.
Step 2
B
Use 10 M6X14 screws to connect the five chair leg tubes to the base.
Step 3
Q
Insert the wheels into the chair legs, then snap the decorative cover onto the chair legs.
Finally, insert the gas lift into the middle hole of the base.
Step 4
Use four M6X20 screws to connect the seat cushion to the mechanism, ensuring
correct front and back alignment.
03
Scan for
Video Guide
A
Decorative
cover
Chair leg
base
N
G
M
H
Step 5
Insert the lumbar support into the backrest slot hole and tighten the lumbar support knob
clockwise.
Step 6
C
D K
Use two M6×25 screws and the armrest fixing device to connect the armrest bracket and
the backrest connector. Finally, put on the armrest decorative cover. Ensure the armrest
bracket intersects with the convex curve of the backrest connector.
Step 7
Use 4 M6X25 screws to connect the backrest and armrests. Use a wrench to tighten them
clockwise to 80% tightness.
Step 8
L
Use 6 M6X35 screws to connect the seat cushion and armrests. Use a wrench to tighten
them clockwise while also tightening the screws connecting the backrest and armrest.
P
E
K
04
Need help?
Do you have a question about the M102C and is the answer not in the manual?