Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Burromax HRH
Summary of Contents for Burromax HRH
- Page 1 OWNERS MANUAL HRH/HRS Models Assembly and Operation...
- Page 2 We encourage all adults to get to know both the Burromax capability and the rider’s skill level prior to allowing anyone operate these vehicles—especially themselves.
-
Page 3: Carton Contents
Carton Contents Located within top of the packing foam you will find the Battery Charger, Front Fender, Rear Fender, Right and Left Footrest Allow up to 30 Min for assembly. assemblies, Handlebar Clamps, all hardware and Tool Kit. The Front Check for all parts and hardware before beginning assembly. -
Page 4: Installing The Front Fender
Rotate the throttle to a good operating position and tighten using a Attaching the Handlebars and Wiring 3mm allen wrench. Rotate the headlight and horn switch to a Tools required: 6mm, 5mm, 3mm,2.5mm Allen wrench comfortable position and tighten using a 2.5mm allen wrench. Turn Place the handlebars in the Lower handlebar clamps on top of the the front fork from side to side making sure that the wires and Front fork. -
Page 5: Installing The Front Wheel
Installing the Front Wheel Installing the Front Brake Caliper Install the front axle into the left fork leg far enough to install the DO NOT Squeeze the brake levers until the brake has been fully first wheel spacer. Hold the front wheel up with the Brake rotor to assembled to the front fork and brake rotor. - Page 6 Adjusting the Brake Caliper Installing The Rear Shock After you have tightened the brake mounting bolts, squeeze the The Rear shock is mounted to the upper frame mount under the brake lever a couple times to set the position of the caliper. seat.
-
Page 7: Checking The Tire Pressure
Checking the Tire Pressure Both tires should be set to 40-45 PSI. We strongly recommend 45 PSI for persons over 175 lb. when riding this product. Proper Tire pressure is VERY IMPORTANT. Do not squeeze the tire and assume it is correct. For the best performance and range this must be checked regularly. -
Page 8: Operation And Functions
The HRH/HRSA has a three (3) position operation. Do not store or use this charger in areas where dirt or switch. -
Page 9: Modes Of Operation
Modes of Operation: 3 Speed Throttles All HR and XR model Burromax electric bikes use a new speed selection arrangement where the Black button on the handlebar controls the 1rst -2 speed selection (low speed and medium speed) and a hidden switch on the side of the battery compartment... - Page 10 3 Speed throttle Speed alteration 100) depending on the model, gearing and tire. All HR and XR model Burromax electric bikes come with a 5. The throttle will count to a maximum of 150 and then go programable speedometer that allows you to changing gearing and back and begin at 50 (minimum).
-
Page 11: Features And Controls
Features and Controls... -
Page 12: Pre-Ride Checklist
It is up to the end user to know the local laws governing are designed for Skilled Riders or Adults and use by others could such vehicles and where they are legal to be ridden. Burromax cause injury, property damage or even death. -
Page 13: Proper Clothing
Jumping or other aggressive riding can over-stress and • Battery Fuse Operation: Your Burromax is equipped with an damage any product, including this electric motorcycle, automatic fuse between the battery and the controller that is... -
Page 14: Charger Warnings
Do not put water directly into the battery 2. Use ONLY Burromax Li-ion Battery Charger Specific to housing vents! High Pressure washing tires, wheels, brakes and the model you purchased. Do not use other MFG chargers... -
Page 15: Running Time
Over Temperature Protections We do not recommend running the bike to cutoff, as it is a real pain Burromax HR Models have over temperature protection in various to push your bike home. If this happens to you, you can wait approx. -
Page 16: Repair And Maintenance
Warning: Turn power switch “OFF” before conducting any maintenance procedures. Inspecting and Replacing the Brake Pads: The HRH/HRS is equipped with Hydraulic brake systems front and rear using Mineral Oil fluid. These Brakes should be inspected every... - Page 17 CHAIN ADJUSTMENT, REAR TIRE AND CHAIN REPLACEMENT Tools required: 5mm Allen wrench ,2- 10mm wrenches, 14mm, 17mm wrench and Chain Lube. Set the bike on a stable platform so that the rear wheel is off the ground. To adjust the chain only perform steps 3, 6, and 7 To replace and adjust the Chain perform steps 1, 3, 5, 6, and 7 To replace or repair the rear tire perform steps 1, 2, 4, 6, 7, 8, 9, Use a 5mm Allen wrench and remove the chain cover screws and...
- Page 18 Hold the adjusting bolt and loosen the Jam nut on the chain adjuster bolts. Turn the chain adjuster bolts one flat at a time counterclockwise to Tighten the chain adjusters. HRH/HRS Axle Assembly Work both sides evenly to remove slack from the chain as B-1 Rear Axle required.
- Page 19 RIDING STYLE to a less aggressive style wrench 3. Test ride Only use the Burromax Li-ion battery and Li-ion Battery charger together. Do Not attempt to replace this battery with anything other than the OEM battery Chain and Sprocket Notes: The chain will typically have a “loose spot”...
-
Page 20: Specifications
3 Speed: 48 Mph Speed mode 1,2, S3 -Programmable Speed Setting USB Ports: Dual 4.5 Amp Fast Charging HRH/HRS Range: (Tested using 200 lb. Rider on Horn: Single Note 100 db Flat Pavement) 1 Speed: 25 Mph --Up to 50 Miles Chassis. -
Page 22: California Prop 65 Warning
For more information, go to www.P65Warnings.ca.gov/passenger-vehicle. Burromax Limited Warranty If you have defects of quality or workmanship Burromax Burromax does not offer an extended warranty. If you will send you replacement parts free of charge for a have purchased an extended warranty, it must be honored period of 90 days from date of purchase.
Need help?
Do you have a question about the HRH and is the answer not in the manual?
Questions and answers