Table of Contents
Advertisement
12.2
Troubleshooting
1
Use a test blank to check before going to a final cut.
2
If you have any problems check stylus heat, stylus
pressure, stylus angle, static build up, cleanliness
of vinyl and any external signal devices you may be
using.
3
If you are still experiencing problems, use a test
blank and record with no input signal.
The vinyl off-cut should be straight(a).
If it is showing big curls the angle of the stylus
should be adjusted, or the stylus should be replaced(b)(e).
If the off-cuts are straight, but very thin,
increase the stylus pressure(c).
If it is curly and too thin, the stylus temperature is too low(d).
If the off-cut breaks as you record,
the stylus temperature is too high(f).
4
Cutting in this way requires experience.
Please take your time, and be patient, using test blanks
to ensure you have the heat, the pressure and the angle
of the stylus all correct.
5
If there is noise on the playback there are two main
reasons. Firstly, if there is random noise or "white
noise" the stylus tip may be broken or the disc is
not clean enough. Secondly, if there is static noise
apply ant static spay and ensure the Ioniser is turned on.
Section 13: PLAYBACK
Before playing back your vinyl cut, please ensure the following:
-
Make sure the surface of the vinyl is totally clean and no off-cuts remain.
-
Make sure the recording arm is all the way to the right and locked.
-
Turn the Ioniser off
Hide quick links:
Advertisement
Table of Contents
