Related Manuals for TechniSat ROADCAM 1 CE
Summary of Contents for TechniSat ROADCAM 1 CE
- Page 1 User Manual FULL HD wide angle car video recorder With G-sensor, GPS, parking mode and motion sensor.
- Page 2 Foreword This manual will assist the user in the intended and safe use of your video recorder, also referred to hereafter as the product, device, camera or equipment. Target group of instructions The instruction manual is addressed to any person who sets up, operates, cleans or disposes of the device.
- Page 3 Legal instructions Local laws and regulations must be strictly observed. The product must not be used for illegal purposes. Otherwise, the user shall bear the responsibility. Safety instructions - The device can only be connected using the supplied car power adapter. - The device cannot be used if the power supply is defective.
- Page 4 - It is recommended to use microSD cards up to a capacity of 32 GB, Class 10 type. - Due to the variety of microSD card models on the market, TechniSat does not guarantee correct operation with all microSD card models. - It is recommended to periodically back up the stored video footage to avoid data deletion.
- Page 5 - If the device will not be used for an extended period of time, its battery should be recharged every month to avoid excessive battery drainage. - Avoid use in the area of strong magnetic fields - The device is not impact resistant! - The operating temperature range of the device is from -10 C to +50...
- Page 6 price into the appropriate containers for re- cycling waste. When you have finished using this appliance, do not dispose of it with normal municipal waste. It must be disposed of at a special collection point for used electrical and electronic equipment.
- Page 7 Contents of set Make sure all the following accessories are available: - ROADCAM 1 CE - User Manual - Car power adapter 12-24V(5V/1.5A output) - Bracket for attaching the camera to the windshield Features of the device - The device has a night mode - The camera has a parking mode.
- Page 8 Construction of the device 10 11 12 1- Indicator lights 5- MENU button 2- MODE button 6- POWER button 3- Up button 7- RESET button 4- Down button 8- MiniUSB connector...
- Page 9 9- Speaker 10- OK button 11- Microphone 12- microSD reader Description of buttons and functions 1) Indicating LEDs The blue indicator on the left side lights up when the device is on, blinks during recording. The red indicator on the right side lights up while charging. When the battery is fully charged, the indicator goes out.
- Page 10 to open or close the audio recording function. 5) MENU button A short press of this button brings up the settings menu. Briefly pressing this button in the mouth menu continuously switches between mouths; Briefly pressing this button while recording locks the current video file.
- Page 11 not a battery or to provide power not necessary for the operation of the device. 9) Speaker To play video content with sound. 10) OK button Confirmation button for taking videos and photos. In video mode, briefly press this button to start recording, briefly press again to stop recording.
- Page 12 of the accident and will save it as a non-removable file. G-sensor can be set in the menu. There are 4 sensitivity settings; Off/Low/Medium/High. Medium is the factory default setting. Recording security function Briefly pressing the MENU button while recording, the device will save the current video as a non- erasable file, and the key icon will be illuminated on the screen.
- Page 13 Colour - when the ambient brightness level is lower than the specified value for at least 5 seconds , the device will automatically turn on the IR LEDs and enter color night mode. When the brightness level of the ambient light is higher than the specified value and remains constantly above this value for 5 seconds , the device will automatically return to normal recording mode.
- Page 14 To activate the parking mode function, please select "Enable". When the parking monitoring function is on- is displayed After leaving the car, when the car is nara-. married to a slight vibration, the device will automatically start up and turn off automatically after 20 se- conds of video recording (once parking moni- torizing starts, the device screen will not turn on, only the blue indicator light will work).
- Page 15 diodes. Note: While the recording function is active, you cannot change modes with the MODE button. First, turn off recording by pressing the OK button. Photo mode - Please press the MODE button you enter photo mode.
- Page 16 Video/Photo playback mode - Briefly press the MODE button to enter playback mode; the playback icon is displayed in the upper left corner of the screen. - Using the "up" or "down" arrow buttons, please select the desired video or photo material to be displayed.
- Page 17 Selection. - Use the "up" or "down" arrow buttons to change the year/month/day and hour/minutes, respectively. - Accept the entered values with the OK button. - A short press of the MENU button exits the settings. USB mode - Please connect the device to your computer with a USB cable - "Ma- sory memory"...
- Page 18 Battery instructions There are three ways to charge the battery; the red indicator will light up while charging; the time to fully charge is about 120 minutes; the indicator will turn off automatically when charging is complete. 1. Use a car power adapter for charging. 2.
- Page 19 (depending on whether car is stationary or in motion). - Use GPSPlayer to display the recorded route. (www.technisat.pl) The speed data is displayed live on the camera's screen and during playback of the video ma- terial, along with the date and time.
- Page 20 Device specifications G-sensor (sensor Built-in (during wy- acceleration) case the video file is saved 1,5" OSD language PL, EN, DE, RU, UA, CZ, HU, GR, IT, NL SK, RO Video format Compression H.264 , Audio: AAC SD card slot 8 to 32 GB (Class 10) Resolution photos Photo format...
- Page 21 Problem solving No possibility Check that the SD card is not video recording filled Recording zos- Change the microSD card to a compatible one STAYED min. with Class 10. The recorded video is characterized by a high throughput of Displays Please format the SD card file error Unclear...
- Page 22 Visible interfe- Incorrectly set frequency- rence transverse wattage. Please set to 50Hz or 60Hz, according to the local power frequency. In te- ren of Poland, please set to 50 Hz. The camera hangs Please perform a reset to Factory settings with the RESET force button.
- Page 23 Customer Service tel: 071 310 41 41 e-mail: biuro@technisat.pl Open Monday through Friday : 8:00-16:00 ROADCAM 1 CE (76-4960-00) carries the CE mark and meets the standards required by the EU. TechniSat reserves the right to changes and printing errors.
Need help?
Do you have a question about the ROADCAM 1 CE and is the answer not in the manual?
Questions and answers