Manikin Electronic modul 3 User Manual

Transformer isolator

Advertisement

User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the modul 3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Manikin Electronic modul 3

  • Page 1 User Manual...
  • Page 2 To be able to use the modul 3 as quickly and effectively as possible, you should take the time to read this manual thoroughly. The Manikin team hopes you enjoy reading it.
  • Page 3: Table Of Contents

    Inhaltsverzeichnis 1. Introduction................1 2. Initial operation..............3 3. Mode of operation..............4 4. Controls & Connectors............4 5. Basic operation..............5 6. Technical Data..............6 7. Disposal.................7...
  • Page 4: Introduction

    Do not expose the appliance to direct sunlight.  Do not expose the appliance to strong vibrations.  1.3 Power connection The module 3 is a passive module that does not require a power supply from the Eurorack. modul 3 User Manual...
  • Page 5 1.4 Operation When operating the modul 3, ensure that it is installed correctly in your  Eurorack. Make sure that no objects get into the module. If this does happen,  switch off the device, pull out the mains plug and then contact a qualified specialist dealer.
  • Page 6: Initial Operation

    4 mounting screws for mounting the modul 3 in the Eurorack  2.2 Installation in the Eurorack The modul 3 has been developed for use in a Eurorack. All cables and screws required for installation and operation are included in the scope of delivery.
  • Page 7: Mode Of Operation

    3. Mode of operation The modul 3 is a highly efficient audio isolator similar to a DI box. An asymmetrical audio signal generated in the Eurorack is balanced using a transformer and output at the output of the modul 3 on an XLR socket. To prevent ground loops and thus “hum”, the ground of the Eurorack can be...
  • Page 8: Basic Operation

    (2, Output). You can use an XLR cable for this. By turning the level potentiometer (3), you can adjust the output level of the modul 3 to the input conditions of your mixing console, active loudspeaker or similar. The ground lift switch (2) makes it possible to disconnect the signal output (2) from the ground potential of your Eurorack, thus preventing the occurrence of ground loops and the “humming”...
  • Page 9: Technical Data

    : Audio Transformer (Oxford Electrical Products Ltd.) Inputs : 1x 3,5mm Phone Jack (mono) Outputs : 1x XLR-Jack 1x 3,5mm Phone Jack (mono) Power Supply : passive Dimensions (W/H/D) : 8HP / 3U / 35mm Weight : 170g modul 3 User Manual...
  • Page 10: Disposal

    For information on disposal facilities, please contact your local authority or the store where you purchased this product. modul 3 User Manual...
  • Page 11 C 2025 by Manikin Electronic All rights reserved www.manikin-electronic.com...

Table of Contents