Task Lighting T-Q-1Z-WC-RF-WT Manual

Battery Warnings & Safety
Warnings and Statements:
This product contains a CR Coin Cell Lithium Battery and meets the requirements
of 16 CFR Part 1263. For your safety and to ensure proper operation, please
carefully read and understand the following warnings and statements.
Use One, Two, or Four Zone Wireless Controllers with single-white and tunable-white lighting.
One Zone Controller
T-Q-1Z-WC-RF-WT
Click to turn
lights on.
Click to turn
lights off.
Press and hold
to brighten
lights.
Press and
hold to dim
lights.
96-Watt Receiver
Press Learning button
T-Q-WR96
Pairing Wireless Controller to a standard receiver (T-Q-WR96 or T-Q-WR240)
Pairing Instructions to one zone (T-Q-WR96 shown in illustrations).
1. Remove Controller from back plate. Use
included screw driver to remove screw, slide
battery compartment open, remove battery,
and discard clear plastic tab. Reinsert battery,
replace cover, and screw down.
Pairing Instructions for additional zones
1. When pairing additional zones to the same
Controller, clear the memory on the new Receiver
for the next zone by pressing and holding the
"Learning Key" button until the lights blink.
Follow instructions included in receiver or lighting to properly hookup lighting system.
Design Services/Technical Support: 866.848.9094 | DesignAndSupport@TaskLighting.com | www.TaskLighting.com
One, Two, and Four Zone Controllers
Pairing instructions to receiver
ZONE 1
Click to turn lights
on. Press and hold
to brighten lights.
ZONE 2
Click to turn lights
on. Press and hold
to brighten lights.
2. If setting the receiver up for the first time,
clear the memory by pressing and holding the
"Learning Key" button until the lights blink.
2. Very quickly, click and release the "Learning Key" button and, within 5
seconds, quickly click and release one of the "Up arrow" buttons on the
Controller. When lights blink once, Controller and Receiver are paired.
Repeat process until zones are paired as desired.
Two Zone Controller
T-Q-2Z-WC-RF-WT
ZONE 1
Click to turn lights
off. Press and hold
to dim lights.
ZONE 2
Click to turn lights
off. Press and hold
to dim lights.
240-Watt Receiver
Press Learning button
T-Q-WR240
Four Zone Controller
T-Q-4Z-WC-RF-WT
ZONE 1
On
ZONE 2
On
ZONE 3
On
ZONE 4
On
Click the up arrow to turn
lights on. Press and hold to
brighten lights.
3. Very quickly, click and release the "Learning
Key" button and, within 5 seconds, quickly click
and release one of the "Up arrow" buttons on the
Controller. When lights blink once, Controller and
Receiver are paired.
NOTE: when pairing additional controllers to the
same receiver, DO NOT clear the memory.
Accessories
ZONE 1
Off
ZONE 2
Off
ZONE 3
Off
ZONE 4
Off
Click the down arrow
to turn lights off. Press
and hold to dim lights.
INST_WC_0624