Table of Contents
Advertisement
Quick Links
Flat Face coupling Series FF
Contents
1.
Preliminary remarks ....................................................................................................... 2
2.
Compatibility ................................................................................................................... 2
3.
Before coupling .............................................................................................................. 2
4.
Connecting the coupling halves ...................................................................................... 3
5.
In operation .................................................................................................................... 5
6.
Disconnecting the connection ......................................................................................... 5
7.
Replacing the seal .......................................................................................................... 6
8.
Notes and contact information ........................................................................................ 6
R0.0_en
Translation of the original
operating instructions
Designation: QRC-FF-...
Advertisement
Table of Contents
Related Manuals for STAUFF FF Series
Summary of Contents for STAUFF FF Series
-
Page 1: Table Of Contents
Translation of the original operating instructions Flat Face coupling Series FF Designation: QRC-FF-... Contents Preliminary remarks ....................... 2 Compatibility ........................2 Before coupling ......................2 Connecting the coupling halves ..................3 In operation ........................5 Disconnecting the connection ..................5 Replacing the seal ...................... -
Page 2: Preliminary Remarks
ISO 16028. Therefore, when using a coupling half with another coupling half (not from the FF series), it must be checked whether the maximum operating pressure of this other coupling is at least equal to the respective operating pressure of the application. -
Page 3: Connecting The Coupling Halves
FF male tip Sliding sleeve FF female body Figure1 . Coupling process: FF male tip concentrically applied to FF female body Figure2 . Coupling process: FF male tip inserted into the FF female body shortly before engaging 3 / 6 www.stauff.com... - Page 4 180° angle to each other, are not aligned with the ball in the base body, see Figure 4. Recess Safety ball Figure4 . Fully engaged state Sliding sleeve rotated relative to the ball in the base body of the sleeve 4 / 6 www.stauff.com...
-
Page 5: In Operation
After the coupling halves have been separated from each other, they must be cleaned with suitable agents if necessary (see also chapter 2), protected against dirt with dust caps and stored in such a way that they are protected against damage, e.g. from impact with other objects. 5 / 6 www.stauff.com... -
Page 6: Replacing The Seal
8. Notes and contact information Note: Any disassembly of individual coupling halves (male tip/ female body) will invalidate the warranty!!! Walter Stauffenberg GmbH & Co. KG Im Ehrenfeld 4 58791 Werdohl +49 2392 9160 +49 2392 916 103 sales@stauff.com www.stauff.com 6 / 6 www.stauff.com...
Need help?
Do you have a question about the FF Series and is the answer not in the manual?
Questions and answers