Daikin FTXC20EV1B Operation Manual page 6

Preparation Before Operation
Accessories
The following accessories are included.
Drywall
Battery
screw
2 2
Disposal Requirements
The batteries supplied with the controller are marked with this symbol.
This means that the batteries shall not be mixed with unsorted household waste.
If a chemical symbol is printed beneath the symbol, this chemical symbol means that the battery contains a heavy
metal above a certain concentration.
Possible chemical symbols are:
 Pb: lead (>0,004%)
Waste batteries must be treated at a specialized treatment facility for re-use.
By ensuring correct disposal, you will help to prevent potential negative consequences for the environment and human health.
Please contact your local authority for more information.
 About batteries
• Remove the batteries from the remote controller if the air conditioner will not be used for an
extended period of time.
• When replacing the batteries, it is advised to replace both batteries together with batteries of the
same type.
• Batteries should be replaced once a year. However, if the display of remote controller started
to fade or there is a noticeable degradation in performance, replace both batteries with new
AAA:LR03 batteries.
• The attached batteries are provided for initial use of the air conditioner. The usage period of
these batteries depends on the manufactured date of the air conditioner.
To operate the remote controller
• Aim the transmitter of the remote controller at the
receiver of the indoor unit.
• Ensure there is no blockage such as curtain between
the indoor unit and the remote controller, signal
transmission will be unsuccessful.
To fi x the remote controller holder on the wall
1. Choose a location where signal is able to reach the unit.
2. Fix the holder onto a wall, a pillar or etc with the screws
supplied with the holder.
3. Place the remote controller on the holder.
 About remote controller
• Do not drop nor wet the remote controller.
• Never expose the remote controller under direct sunlight.
• Dust on the transmitter lense cover will reduce the sensitivity.
• Signal communication may be affected if the air conditioner is being installed near an electronic-
starter-type fl uorescent lamp (such as inverter-type lamp) in the room.
Remote
Controller Holder
1
To set the batteries
1. Remove the back cover by sliding downwards.
2. Insert two dry batteries (LR03:AAA).
3. Replace the back cover.
Position
correctly!
Remote controller
ENGLISH
and
Receiver
Screws
Remote controller holder
6