G
B
A
Vibe Rechargeable LED Ring Desk Lamp
CS309G5W
INS240810
H
K
J
E
C
D
Li-ion Battery - Model: 18650
Capacity: 1500mAh (5.55 Wh). Output Voltage: 3.7V
NOTICE:
Never disassemble by yourself. Use the authorized charger only. Exposure of
battery to open flames could cause explosion.
Do not expose the battery pack out of the temperature range 32°F to 113°F
(0°C~45°C)
Do not incinerate.
Battery is not replaceable.
Properly dispose in accordance with local regulations for hazardous waste.
MADE IN CHINA
ENGLISH
CONGRATULATIONS! You've purchased the finest in natural lighting
technology with your new OttLite
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it
today by mail, or register online by going to: OttLite.com/warranty
WARNING: To prevent electric shock, make sure the lamp is not plugged
in until all steps are complete.
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove lamp from packing, placing lamp body base (A) flat on a steady
surface.
2. I/O Switch (C) can toggle into two positions (left and right). The light will
not turn on when the switch is in the right-position. Toggle the switch to
left-position so the light will be able to turn on.
3. PLEASE NOTE: This lamp will function while the USB charging cable
is plugged into a power source OR on its own internal battery. When
using on battery power and the light starts to dim, this indicates that the
internal battery needs to be recharged. Charging will occur regardless
of the position of I/O Switch (C).
4. To recharge the battery, plug micro-USB connector (D) into port (E)
in the rear-bottom of the lamp. Then plug USB-A connector (F) into a
standard 5V, 0.5A USB power source such as a computer USB Port or
a USB power adapter (not included). LED indicator (J) will change from
RED to GREEN when lamp is fully charged.
5. With I/O Switch (C) in the left-position, turn the lamp ON/OFF by using
power switch (B) located on top of base (A).
6. Press and hold power switch (B) to adjust brightness until desired
brightness level is achieved, then release.
7. Touch power switch (B) to change the color temperature of the light.
This lamp has 3 color modes.
8. To reposition the light, hold the lamp base (A) steady and grasp either
flex-neck (G) or shade (H) depending on needed adjustment. DO NOT
FORCE the shade or lamp body outside allowable adjustable range as
excessive adjustment may cause damage.
SAFETY WARNING:
SHOCK, OR INJURY TO PERSONS
1. Turn lamp off and WAIT UNTIL LAMP HEAD IS COOL before handling.
2. The LED panel (K) might get hot after several hours of continuous use
F
DO NOT place your hands directly on LED light panel.
3. The lamp head included with this unit cannot be replaced by the
consumer.
4. INDOOR USE ONLY.
NOTE: The important safety instructions appearing in this instruction sheet
are not meant to cover all possible conditions and situations that may occur.
It must be understood that common sense, caution, and care must be used
with any electrical product.
CAUTION!
THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE;
WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL
BE REPLACED.
L078
Vibe Rechargeable LED Ring Desk Lamp
CAUTION: Any change or modification to product not expressly recognized
®
product.
by OttLite voids OttLite's responsibility for proper function of product.
FCC PART 15
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
the interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
CAN ICES-005 (B)/NMB-005 (B)
Specifications
USB: 5V, 0.5A / Input power: 5V, 0.5A
Built-in Lithium Battery: 3.7V / 1500mAh (power for LED light)
Accessories:
• USB charging cable
TO REDUCE THE RISK OF FIRE, ELECTRIC
REV081524
Need help?
Do you have a question about the Vibe Rechargeable LED Ring Desk Lamp and is the answer not in the manual?
Questions and answers