Related Manuals for MH LONDON Etna MH-TB-891
Summary of Contents for MH LONDON Etna MH-TB-891
- Page 1 All manuals and user guides at all-guides.com 15 : 00 2 or more estimated people required assembly time...
- Page 2 All manuals and user guides at all-guides.com Ok, let’s get started! Put on mood music! To prevent damage to product, use the clean side of package carton or rug as working surface for assembly. In the event of missing or damaged parts, delivery problems etc., please reach out to our team.
-
Page 3: Care Guide
All manuals and user guides at all-guides.com care guide Clean regularly with a soft and dry cloth. To protect finish, avoid use of abrasive cleaners. Wipe up spills immediately. Please! While assembling the product, tighten the bolts up to 50%. Once all parts are in place, only then fully tighten the bolts. -
Page 4: Product Parts
product All manuals and user guides at all-guides.com parts Tabletop Table Legs... -
Page 5: What's Included
what’s All manuals and user guides at all-guides.com included (D) -Washer (E)-Lock Washer (Ø18mmxØ8mm) (Ø15mmxØ8mm) (F) -Bolt (G) -Bolt (M6x20mm) (M6x10mm) (H)- Allen key (Ø4mmxØ110mm) - Page 6 All manuals and user guides at all-guides.com assembly instructions Friendly Tip: Take a deep breath going in. This may be a tricky part, but nothing too overwhelming. Just follow these steps to the T and the outcome will be worth it! While assembling the product, tighten the bolts up to 50%.
- Page 7 All manuals and user guides at all-guides.com step 1: Start by placing tabletop (A) upside down. Taking this image as reference, insert table leg (B) into the preinstalled rods on tabletop (A). step 2: Slide rod (C) onto the table leg (B) as shown in the image. Next, insert the other table leg (B) into rod (C) and the preinstalled rods on the tabletop.
- Page 8 All manuals and user guides at all-guides.com step 3: Check out the holes on rod (C) and the preinstalled rods as highlighted in the image. That’s where you’ll be inserting bolts (G). step 4: Using bolts (G) and allen key (H), secure them in place.
- Page 9 All manuals and user guides at all-guides.com step 5: Refer to the highlighted areas to see where you’ll be inserting bolts (F) next. step 6: Placing lock washer (E) on top of washer (D), fasten bolt (F) on all four holes using allen key (H). Voila! Your table is now assembled and secure!
- Page 10 All manuals and user guides at all-guides.com...
Need help?
Do you have a question about the Etna MH-TB-891 and is the answer not in the manual?
Questions and answers