AEG FSE77738P User Manual
  1. Manuals
  2. Brands
  3. AEG Manuals
  4. Dishwasher
  5. FSE77738P
  6. User manual
AEG FSE77738P User Manual

AEG FSE77738P User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
aeg.com/register
EN User Manual | Dishwasher
FSE77738P
aeg.com\register

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FSE77738P and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for AEG FSE77738P

Summary of Contents for AEG FSE77738P

  • Page 1 EN User Manual | Dishwasher FSE77738P aeg.com\register...
  • Page 2 INSTALLATION min.560 820-900 818-898 max. 1240 670-825 ≤ 5 mm How to install your AEG/Electrolux www.youtube.com/electrolux www.youtube.com/aeg 60 cm sliding door dishwasher...

  • Page 3: Table Of Contents

    Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, troubleshooting, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................3 2. SAFETY INSTRUCTIONS................5 3. PRODUCT DESCRIPTION................7 4. CONTROL PANEL..................7 5.

  • Page 4: General Safety

    • Children should be supervised to ensure that they do not play with the appliance. • Keep detergents away from children. • Keep children and pets away from the appliance when the door is open. • Children shall not carry out cleaning and user maintenance of the appliance without supervision.

  • Page 5: Safety Instructions

    • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2. SAFETY INSTRUCTIONS • Always use a correctly installed 2.1 Installation shockproof socket. • Do not use multi-plug adapters and extension cables.

  • Page 6: Internal Lighting

    2.4 Use discontinued: motor, circulation and drain pump, heaters and heating elements, • Do not put flammable products or items including heat pumps, piping and related that are wet with flammable products in, equipment including hoses, valves, filters near or on the appliance. and aquastops, structural and interior •...

  • Page 7: Product Description

    3. PRODUCT DESCRIPTION Air vent Rinse aid dispenser Detergent dispenser Lower basket Upper basket Cutlery drawer 3.1 QR code on the rating plate The rating plate has a QR code that can be used in two ways. Scan the QR code with the camera on your Ceiling spray arm mobile device to be redirected to the app in Upper spray arm...

  • Page 8: Indicators On The Display

    4.2 Indicators on the display Indicator Description Rinse aid indicator. It is on when the rinse aid dispenser needs refilling. Refer to Before first use. Salt indicator. It is on when the salt container needs refilling. Refer to Before first use. Machine Care indicator.
  • Page 9 dishwashing temperature of the selected ExtraPower improves the dishwashing programme and reduces it to 45 °C. results of the selected programme. The option increases the wash temperature and 5.4 Extras in the app duration. Connect your dishwasher to the app to GlassCare prevents delicate load, access additional dishwashing options.

  • Page 10: Consumption Values

    Programme Dishwasher Degree of Programme phases EXTRAS load soil AUTO Sense Crockery, cut‐ Not applicable • Prewash lery, pots, pans • Dishwashing 50 - 60 °C • Intermediate rinse • Final rinse 60 °C • Drying • AirDry Machine Care For cleaning the appliance interior. Not applicable •...

  • Page 11: Setting Mode

    Settings Values Description Water hardness 1 - 10 (default: 5) Adjust the level of the water softener according to the water hardness in your area. Rinse aid level 0 - 6 (default: 6) Adjust the level of the rinse aid according to the neces‐ sary dosage.

  • Page 12: Water Softener

    6.2 Water softener • The display shows the first available setting and its current value. The water softener removes minerals from the water supply, which would have a How to change a setting negative effect on the washing results and on the appliance.
  • Page 13 6.3 Rinse aid level The duration of the drying phase and the door opening time vary depending on the selected The rinse aid helps to dry the dishes without programme and options. streaks and stains. It is automatically When AirDry opens the door, the display released during the hot rinse phase.

  • Page 14: Wireless Connection

    6.7 PNC number the number on the display. Select PNC number from the setting list to check the If you contact an Authorised Service Centre, number. you need to provide the product number code (PNC number) of your appliance. The number can be found on the rating plate on the appliance door.

  • Page 15: Before First Use

    Refer to the instructions provided earlier in The indicator is off. this chapter. Connect the dishwasher to the network and to the app to enter new network credentials. 8. BEFORE FIRST USE 1. Adjust the level of the water softener 4.

  • Page 16: Daily Use

    3. Remove the spilled rinse aid with an CAUTION! absorbent cloth to prevent excessive foam formation. The compartment (B) is for rinse aid only. 4. Close the lid. Make sure that the lid locks Do not fill it with detergent. into position.

  • Page 17: How To Delay The Start Of A Programme

    • The indicator is on. 2. Close the appliance door. Activating options often increases water 3. Use the app to remotely operate the consumption, energy consumption and appliance. programme duration. 9.5 How to start the AUTO Sense Opening the door deactivates the remote program start.

  • Page 18: Hints And Tips

    9.9 How to cancel a running Opening the door while the remote start is programme activated deactivates this function. Activate the remote start again before you close the door; otherwise, the wash cycle starts Press and hold for about 3 seconds. immediately after you close the door.

  • Page 19: Using Salt, Rinse Aid And Detergent

    • Soak or slightly scour cookware with firmly • Always use the correct quantity of rinse cooked-on or baked-on food before aid. Insufficient dosage of rinse aid washing it in the appliance. decreases the drying results. Using too • Make sure that items in the baskets do not much rinse aid results in bluish layers on touch or cover each other.

  • Page 20: Care And Cleaning

    10.6 Unloading the baskets • Do not wash in the appliance items that can absorb water (sponges, household 1. Let the tableware cool down before you cloths). remove it from the appliance. Hot items • Put hollow items (cups, glasses and pans) can be easily damaged.

  • Page 21: External Cleaning

    11.3 Removal of foreign objects Check the filters and the sump after each use of the dishwasher. Foreign objects (e.g. pieces of glass, plastic, bones or toothpicks, etc) decrease the cleaning performance and can cause damage to the drain pump. CAUTION! If unable to remove the foreign objects, contact an Authorised Service Centre.

  • Page 22: Cleaning The Upper Spray Arm

    2. Wash the spray arm under running water. Use a thin pointed tool, e.g. a toothpick, to remove particles of soil from the holes. 11.8 Cleaning the ceiling spray arm Run water through the holes to wash soil particles away from the inside. The ceiling spray arm is placed on the ceiling 3.

  • Page 23: Troubleshooting

    5. To install the spray arm (C) back, insert turning it clockwise. Make sure that the the mounting element (B) in the spray mounting element locks into place. arm and fix it in the delivery tube (A) by 6. Install the cutlery drawer on the sliding rails and block the stoppers.
  • Page 24 Problem and alarm code Possible cause and solution The temperature of the water inside • Make sure that the temperature of the inlet water does not exceed the appliance is too high or malfunc‐ 60°C. tion of the temperature sensor oc‐ •...
  • Page 25 Problem and alarm code Possible cause and solution The appliance is switched on but • Power supply is out of the operating range. The dishwashing cycle is does not operate. temporarily interrupted and resumes automatically once the power is The display shows Power Fail. restored.
  • Page 26 Problem Possible cause and solution Stains and dry water • The released quantity of rinse aid is not sufficient. Adjust the dosage to a higher drops on glasses and level. dishes. • The quality of the rinse aid can be the cause. The interior of the appli‐...

  • Page 27: Technical Data

    12.2 Problems with wireless connection Problem Possible cause and solution Activating wireless connection is not • Wrong wireless network ID or password. Cancel the setup and start successful. it again to enter the correct credentials. Refer to "Wireless connec‐ tion" chapter. •...

  • Page 28: Environmental Concerns

    13.1 Link to the EU EPREL database product number that you can find on the rating plate of the appliance. Refer to the The QR code on the energy label supplied "Product description" chapter. with the appliance provides a web link to the registration of this appliance in the EU 13.2 Link to the product information EPREL database.
  • Page 32 The software in this product contains components that are based on free and open source software. AEG gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://aeg.opensoftwarerepository.com (folder NIUS)

Table of Contents