Humminbird MEGA LIVE 2 SHAFT MOUNT Installation Manual

MEGA LIVE 2 SHAFT MOUNT Installation Guide
Following are instructions for the installation of this accessory. Before you start installation,
we encourage you to read these instructions carefully in order to get the full benefit from your
Humminbird® accessory.
For more information about the installation of your MEGA Live 2 Imaging transducer,
see the installation guide that was included with your transducer or visit our Web site at
humminbird.johnsonoutdoors.com.
Read the instructions in this guide completely to understand the mounting guidelines before
beginning the installation.
Supplies: In addition to the hardware supplied with your accessory, you will need a bit driver.
Your trolling motor should be in the fully retracted (flat) position on the boat deck for this
installation.
Disconnect Power: For installation on a trolling motor, disconnect the trolling motor from all
sources of electrical power before you start the installation.
Visit our Web site at humminbird.johnsonoutdoors.com for additional information and resources for
transducer installations. Also, visit youtube.com/humminbirdtv for informational videos.
Installation Overview
| Attach the Landscape Mount to the Shaft Mount
1
1. Fold the Landscape Mode mount down using the dual release buttons.
2. For installation on an Ultrex or Fortrex trolling motor, secure the included small rubber pads to
the inside of the shaft mount as shown in the illustration Shaft Mount Rubber Pad Placement.
Remove the backing from the pads and press the adhesive sides firmly into place against the
shaft mount.
For installation on an Ultrex QUEST trolling motor, rubber pads are not needed. Proceed to Step 3.
3. Align the key on the shaft mount and the Landscape Mode mount to connect them.
4. Secure the shaft mount with one of the included lock washers and 1/4-28 screws, using the provided
1/8" hex bit and a bit driver. Hand tighten the screw until the lock washer is fully compressed (see
the illustration Compressing the Lock Washer), and then tighten an additional 1/4 turn. Hand
tighten only!
The screw and lock washer MUST be fully tightened. Failure to do so may result in the
Landscape Mode mount detaching from the shaft mount in the water.
NOTE
Installation Preparation
CAUTION
532967-3_A
Landscape Mode Mount
single
release
button
Shaft Mount Rubber
Pad Placement
shaft
mount
rubber
pads
Connecting the Shaft Mount
to the Landscape Mode Mount
The
ratchets
are keyed.
1
dual
release
buttons
Center the
pads here.