Setting up Your Remote https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 3
If the device turns on or off, you have finished programming 4. If you have tried all the codes listed for the manufacturer and the device does not respond, refer to the CodeScan™ section later in this manual https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 5
Setting up your Remote for an Auxiliary Device https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 6
If the device turns on or off, you have finished programming. If you have tried all the codes listed for the manufacturer and the device does not respond, refer to the CodeScan™ section later in this manual. https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 9
? key to find another code that turns off the device. Then test the functions again 8. When you are satisfied that all primary functions are working, press OK to lock in the code https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 11
Recalling a Device Code https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 12
◦ A pause separates each digit ◦ For example, three flashes represent the number 3 ◦ Rapid flashing represents 0 3. Count and record the sequence of flashes to determine the three-digit code https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 14
Programming Volume Control https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 15
2. Press CABLE. The CABLE key will flash three times and turn off 3. You now control the volume through the TV whenever you change the volume level in Cable mode https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Page 21
2. Check battery polarity carefully, and install the batteries as shown in the illustration below 3. Replace the battery compartment cover IMPORTANT NOTE: Weak batteries may disrupt normal operation of the remote https://astound-prod.mindtouch.us/all-equipment/remote-controls/remotes-ca-or-wa/uf4-200c Updated: Sat, 08 Mar 2025 01:19:51 GMT Powered by...
Need help?
Do you have a question about the UF4-200C and is the answer not in the manual?
Questions and answers