Guide Sensmart PR II Series Quick Start Manual

INFRARED THERMAL IMAGERS FOR FIRE SERVICE
Downloads
Infrared analysis software Infrared analysis software
installation package User Manual
【windows】
FCC warning
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Thermal Camera
User Manual
INFRARED THERMAL IMAGERS FOR FIRE SERVICE
Quick Start Guide
2~3s
③
①
②
Thank you for choosing this product. Please read this Guide before use and properly keep it for
future reference. We hope that the product meets your expectations.
①
500~2000℃
②