Toro 79348 Addendum

Powered Twin Bagger
TITAN
Model No. 79348—Serial No. 400000000 and Up
This Addendum replaces the existing Installing the Weights procedure in the Operator's Manual for the powered
twin bagger. Store this document with the Operator's Manual.
1
Installing the Weights
Parts needed for this procedure:
1 Left weight mount
1 Right weight mount
4 Bagger weight
6 Bolt (3/8 x 1 inch)
2 Bolt (3/8 x 2-3/4 inches)
2 Washer
8 Flange nut (3/8 inch)
Procedure
CAUTION
The bagger changes the weight distribution of
the machine. Operating the machine without
the front weights may cause an unstable
condition, which could result in a loss of
control.
Ensure that the front weights are properly
installed before operating the machine with
the bagger attachment.
1. Use 6 bolts (3/8 x 1 inch) and locknuts (3/8 inch)
to secure the left and right weight mounts to the
front of the machine as shown in
© 2025—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Zero-Turn-Radius Riding Mower
Figure 1.
Register at www.Toro.com.
Figure 1
1. Right weight mount
2. Bolt (3/8 x 1 inch)
2. Install the bagger weights (amount determined
by deck size) to the weight mounting brackets
to the weight mounts with 2 bolts (3/8 x 2-3/4
inches), washers, and locknuts (3/8 inch) as
shown in Figure 2.
Titan models
Deck Size Weights Required
48-inch 3
54-inch 2
60-inch 1
Titan Max models
Deck Size
60-inch
Important:
Adjust the amount of weight
according to the size of the mower deck.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3473-236 Rev A
Addendum
g462067
3. Locknut (3/8 inch)
4. Left weight mount
Weights Required
4
*3473-236*