Miller API HPW33 Instructions

FEATURES:
• Easy to fill 3-gal. capacity reservoir and
wide base provides long lasting easy
drinking access.
• Thermostatically controlled UL listed
electrical components to ensure safe
ice-free operation from 35ºF to -5F.
WARNING
The Heated Poultry Water #HPW33 is an
indoor electrical appliance that requires
basic safety precautions to reduce the risk
of product damage, electrical shock, and
personal injury. Read all precautions and
instructions before using this product.
CAUTION
• Only use this product in a dry indoor area
on a hard flat level surface.
• Inspect the power cord and plug for cracks
and other damage before each use. Do
not use this product if any of the product
components have been damaged.
• Connect this product to a properly installed
Ground Fault Circuit Interrupter (GFCI)
outlet. Only use extension cords that are
properly sized for unit's operation.
• Disconnect the power cord when filling the
reservoir.
• Do not immerse the product base in water
at any time.
• Do not overfill.
• Disconnect the power cord when the
product is not in use and during warm
weather (ambient temperatures above
50ºF).
• Do not dismantle or modify the product
in any way. Product modifications may
make the product unsafe and will void the
warranty.
• Store the product indoors when not in use.
HEATED POULTRY WATERER
Item #HPW33
WARRANTY
Miller Manufacturing Company products
are warranted to the original purchaser
to be free from defects in material and
workmanship under normal use and service.
Miller's obligations under this Warranty shall
be limited to the repair or exchange of any
part of parts which may thus prove defective
under normal use and service within 12
months from the date of shipment by Miller
to the original purchase, and which Miller's
examination shall disclose to its satisfaction
to be thus defective. The warranty is voided
if there is evidence of general abuse such as
animals chewing on the cord. This warranty
does not cover incidental or consequential
damage resulting from either a defect
in parts, materials or operation failure.
Purchaser must deliver any part or parts
to: Miller Manufacturing Company, 1450
West 13th Street, Glencoe, MN 55336 for
examination. This Warranty does not apply
to damage caused by misuse or neglect
in the field, or failure to follow installation
instructions.
Operation:
1. Guide the reservoir all the way into the
inner ring of the base.
2. Turn the reservoir clockwise to the closed
position. In this position the reservoir
should be locked onto the base with the
water passage closed.
3. Turn the unit upside down and rest it on
the four supports molded into the top of
the reservoir.
CLOSE
Miller Manufacturing, Glencoe, MN 55336 USA • www.miller-mfg.com
Read Instructions Thoroughly Before Use
4. Make sure unit is unplugged before filling.
Lift the black rubber stopper from the base
and fill the reservoir as needed. Hold the
unit steady during filling to avoid spills.
5. Push the black rubber stopper securely
into the base.
6. Turn the unit right side up and place it in
the desired location (indoors on a hard flat
level surface out of the wind).
7. Inspect the power cord for cracks or
damage. Do not use if power cord is
damaged.
8. Connect the power cord directly to a
properly installed GFCI outlet. The power
cord has a 2 prong polarized plug (one
blade is wider than the other). The plug
is designed to fit into the outlet one way
only. Do Not force the plug into the outlet.
9. Turn the reservoir counter clockwise until
it stops. In this position, the reservoir
should be locked onto the base with the
water passage open to fill the base.
NOTE: The flow of water from the reservoir
to the base will stop automatically once the
base is full. The unit is designed to maintain
the level of water in the base automatically
as long as the reservoir and water passage
are in the Open position.
FILL
OPEN
1002088