Download Print this page

Eagle Group KBD-2 Assembly Instructions

Keyboard drawer

Download this manual

#KBD-2 Keyboard Drawer

INSTRUCTION SHEET

#337412

ASSEMBLY INSTRUCTIONS

See pages 2 & 3 for assembly to Wire Shelf 24˝ (front-to-back).

See back page for assembly to Wire Shelf 30˝ or greater (front-to-back).

CAUTION

INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING

CARRIER FOR ANY DAMAGE.

SAVE YOUR BOX AND ALL PACKING MATERIALS.

YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED IMPROPERLY PACKED.

Thank you for your purchase. Before assembly, read this instruction sheet carefully.

After reading, be sure to store this instruction in a safe place, should it be needed for future reference.

Parts List

qty

description

1 .......... 4 ............... brackets

2 .......... 1 ............... keyboard drawer

hardware (not shown)

4 ............... screws

(continued on back page)

EG9820 Revised 04/25

Need help?

Do you have a question about the KBD-2 and is the answer not in the manual?

Page 1 #KBD-2 Keyboard Drawer INSTRUCTION SHEET #337412 ASSEMBLY INSTRUCTIONS See pages 2 & 3 for assembly to Wire Shelf 24˝ (front-to-back). See back page for assembly to Wire Shelf 30˝ or greater (front-to-back). CAUTION INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING CARRIER FOR ANY DAMAGE.
Page 2 3rd end-to-end mat wire of shelf. See bracket (right) illustation at right. bracket (left) (top view of 24˝ wire shelf with #KBD-2) center truss Step 2 - Install brackets at rear. of shelf • Position bracket as shown in fig. 2a,...
Page 3 #KBD-2 Keyboard Drawer for 24˝ (front-to-back) Wire Shelf ASSEMBLY INSTRUCTIONS See back page for assembly to Wire Shelf 30˝ or greater (front-to-back) Step 3 - Install brackets at front. front-to-back mat wire (bracket hooked here) Note: These brackets do not intersect with...
Page 4 30˝ or greater (front-to-back) Wire Shelf ASSEMBLY INSTRUCTIONS Assembly of #KBD-2 Keyboard Drawer to a wire shelf 30˝ or greater front-to-back is done in the same manner as assembly to a 24˝ wire shelf (pages 2 & 3). In short, the only difference is that the brackets in the FRONT intersect with a shelf truss, and the brackets at the rear do not.