Output Connections - McIntosh C22 Owner's Manual

OUTPUT CONNECTIONS

There are two sets of outputs on the left
half of the back panel. (See Figure 15) One
pair is marked M A I N . The second pair is
marked TAPE.
The M A I N outputs connect to power
amplifiers (figure 17). The TAPE output feeds
a tape recorder.
The MAIN jacks are fed from cathode
followers. Longer cables than are normally
supplied can be connected between the C22
and the amplifiers. The length of the cable is
limited by the capacity of the cable. The total
capacity must not exceed 1000 mmf. For
10
Figure 16. Turntables feeding low-level inputs.
instance: cables with a capacity of 25 mmf
per foot may be 40 feet long; 13.5 mmf per
foot cable may be 75 feet long. The input
impedance of the amplifiers should be
50,000 ohms or greater.
follower. The program material fed out of the
TAPE output is not affected by these front
panel controls: VOLUME control, BASS con-
trols, LF and HF filter switches, BALANCE
control, LOUD switch, TAPE switch, PHASE
switch, TREBLE controls, and MODE SELEC-
TOR switch.
output is affected by these front panel con-
Figure 17. MAIN OUTPUT Connected to
Power Amplifiers.
The TAPE output is fed from a cathode
The program material fed out of the TAPE