Page 5
Hand 1 x Sliding Rail Set 1 x Fujioh Heater Unit 2 x Wall Plug & Screw Set (1 spare) & rubber grommet 1 x Hand shower 5 spray c/w filter mesh washer & flow restrictor...
Page 6
(For Unit C/W Shower Holder Bracket) 1 x Shower Holder Bracket 2 x Wall Plug & Screw Set 1 x Fujioh Heater Unit (1 spare) & rubber grommet 1 x Hand shower 1 spray c/w filter mesh washer...
Page 13
PLUMBING CONNECTIONS COMPLETE THIS PROCESS BEFORE WIRING CONNECTION CONNECTION PROCEDURE: Connect the water supply to the inlet of the shower via 15mm copper, stainless steel or plastic pipe using a 15mm x 15mm elbow compression fitting. Do not use excessive force when making these connections.
Page 14
Fit the Flexible hose (Warning: Metalic / Chromed Hose shall not be used) by connecting to the unit Outlet (Left side) and hand shower. (Please, make sure to remove one washer from the end of the flexible hose connecting to the hand shower.) Filter Mesh Washer &...
Page 15
The ‘RCD’ sign will light meaning the unit is ON. Turn the knob clockwise to sign, the ‘HEATER’ sign will light up. Turn the knob anti-clockwise to ; the ‘HEATER’ sign will switch OFF.
Page 16
‘HEATER’ and ‘RCD’ sign light will turn OFF.
Page 20
3.5kW, 220V AC, 50Hz 2.60 1.40 2.40 Shower Holder Bracket) 1.40 Shower Holder Bracket) SCHEMATIC WIRING DIAGRAM (FZ-WH5035N) Thermal Cut-out ELECTRONIC CONTROL BOARD FLOW ON/OFF POWER SWITCH SWITCH CONTROL SWT-EC-AS2 TRIAC To Heater Chasis INDICTOR TEST RESET BOARD TEST/RESET HEATING ELEMENT Rev A 01.01.2020...
Need help?
Do you have a question about the FZ-WH5035N1B and is the answer not in the manual?
Questions and answers