NAIM ALLAE Manual page 6

SL2
Stage 2
Take each Tweeter Suspension Assembly
it up to the Tweeter Mounting Points
Plinth. Attach it using the bolts and allen key supplied. The
Tweeter Suspension Assembly
vertical as possible. Use the back of the
a guide.
6.4 SL2 Assembly
Fit a Pin and a Spacer to
the three holes in the
aluminium top surface of
each Lower Cabinet.
There are two holes at
the front and one at the
back.
Tweeter Adjustment Panel
6.5 SL2 Assembly
Take each Upper Cabinet
in turn and carefully lower
it onto the appropriate
Lower Cabinet locating
the Pins in the
corresponding holes on
its underside. At the
same time as each Upper
Cabinet is lowered onto
each Lower Cabinet, the
tweeter must be inserted
through the back and
front apertures of the
Upper Cabinet.
in turn and offer
on the rear of each
should be fixed as close to
Lower Cabinet as
Now move each Lower Cabinet
Assembly attached into the appropriate position. Take care
not to place them so close to the wall that the rear spikes
foul any carpet gripper that may be fitted. Also leave some
space for final adjustment of the
Assembly and for the connecting cables.
Adjust the spikes so that the cabinets are upright (a small
spirit level will help) and do not rock. Tighten the lock-nuts
Tweeter Suspension
Assembly
Pin
Spacer
Upper Cabinet
with the Tweeter Suspension
Tweeter Suspension
with an appropriate spanner.
Check again, once the lock-
nuts are tightened, that the
cabinets do not rock on the
spikes.
Note: With thick carpet and
underlay it can be difficult to
ensure that the spikes are
resting on the floor. Small slits
cut into the carpet once the
loudspeaker position is
finalised will help.
Stage 3
The pack containing this
manual also contains Cabinet
Interface Pins and Cabinet
Spacers. Fit a Pin and a
Spacer to the three holes in
the aluminium top surface of
each Lower Cabinet. There
are two holes at the front and
one at the back. Spare Pins
and Spacers are included in
the pack. The Pins should be
a loose fit in the holes. See
Diagram 6.4
Now take each Upper Cabinet
in turn and carefully lower it
onto the appropriate Lower
Cabinet locating the Pins in
the corresponding holes on its
underside. At the same time
as each Upper Cabinet is
lowered onto each Lower
Cabinet, the tweeters must be
inserted through the apertures
of the Upper Cabinets. The
loose fit of the Pins allows
some adjustment of the
alignment of the two cabinets.
See Diagram 6.5
5