Milwaukee IR FL500 Manual

IMPORTANT SAFETY
INSTRUCTIONS
READ ALL SAFETY WARNINGS,
WARNING
INSTRUCTIONS,
AND SPECIFICATIONS PROVIDED WITH THIS
POWER TOOL. Failure to follow all instructions listed
below may result in electric shock, fire and/or serious
injury. SAVE THESE
OPERATOR'S MANUAL CONTAINS IMPORTANT
SAFETY AND OPERATING INSTRUCTIONS.
• AVOID DANGEROUS ENVIRONMENTS. Do not
charge battery in rain, snow, damp or wet locations.
Do not use battery or
explosive atmospheres (gaseous fumes, dust or
flammable materials) because sparks may be
generated, possibly causing fire.
CHARGE IN A WELL VENTILATED AREA. Do not
•
block charger vents. Keep them clear to allow proper
ventilation. Do not allow smoking or open flames near
a charging battery. Vented gases may explode.
• MAINTAIN CORD. When unplugging charger, pull
plug rather than cord to reduce the risk of damage to
the electrical plug and cord. Never carry charger by its
cord. Keep cord from heat, oil and sharp edges. Make
sure cord will not be stepped on, tripped over or
subjected to damage or stress. Do not use charger
with damaged cord or plug. Have a damaged charger
replaced immediately.
• USE ONLY RECOMMENDED ATTACHMENTS. Use
of an attachment not recommended or sold by the
battery charger or battery manufacturer may result in
a risk of fire, electric shock or personal injury.
• TO REDUCE THE RISK OF ELECTRIC SHOCK,
always unplug charger
maintenance.
• DO NOT BURN OR INCINERATE BATTERY
PACKS. Battery may explode, causing personal
injury or damage. Toxic fumes and materials are
created when battery are burned.
• DO NOT CRUSH, DROP, OR DAMAGE BATTERY. • DO NOT CRUSH, DROP, OR DAMAGE BATTERY.
Do not use a battery or charger that has received a Do not use a battery or charger that has received a
sharp blow, been dropped, run over, or damaged in sharp blow, been dropped, run over, or damaged in
any way (e.g., pierced with a nail, hit with a hammer, any way (e.g., pierced with a nail, hit with a hammer,
stepped on). stepped on).
• DO NOT DISASSEMBLE. Incorrect reassembly may
result in the risk of electric shock, fire or exposure to
battery chemicals. If it is damaged, take it to a
service facility.
MILWAUKEE
®
• BATTERY CHEMICALS CAUSE SERIOUS BURNS.
Never allow contact with skin, eyes, or mouth. If a
damaged battery leaks battery chemicals, use rubber
or neoprene gloves to dispose of it. If skin is exposed
to battery fluids, wash with soap and water and rinse
with vinegar. If eyes are exposed to battery
chemicals, immediately flush withwater for 20 minutes
and seek medical attention. Remove and disposeof
contaminated clothing.
• DO NOT SHORT CIRCUIT. Do not allow fluids to flow
into tool. Corrosiver conductive fluids, such as
seawater, certain industrial chemicals, and bleach or
bleach containing products, etc., can cause a short
circuit. A short circuited battery pack may cause fire,
personal injury, and product damage.
INTERNAL RECHARGEABLE FLASHLIGHT
500 LUMEN
ILLUSTRATIONS
INSTRUCTIONS-
harger in the presence of
before cleaning
• STORE in a cool, dry place. Do not store battery
where temperatures may exceed 50°C (120°F) such
as in direct sunlight, a vehicle or metal building during
the summer.
• TO REDUCE THE RISK OF INJURY, CLOSE
SUPERVISION IS NECESSARY when an appliance
is used near children.
• STORE IDLE
CHILDREN. Warm lights can become hazardous in
the hands of children.
• KNOW YOUR LIGHT. Read this manual carefully to
THIS
learn your light's applications and limitations as well
as potential hazards associated with this type of light.
• MAINTAIN LABELS AND NAMEPLATES. These
carry important information. If unreadable or missing,
contact a MILWAUKEE
replacement.
ADDITIONAL BATTERY
SAFETY RULES
WARNING
short circuit, never immerse your tool, battery pack or
charger in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as seawater,
certain industrial
bleach-containing products, etc., can cause a short
circuit.
WARNING
SPECIFICATIONS
Cat. No. ...................................................... IR FL500
Volts.................................................................. 4V DC
Watts...................................................................... 6W
or
IP Rating.................................................................. 67
Lumens.................................................................. 500
USB Input Volts ................................................ 5V DC
USB Input Amps .......................................... 0.1A-1.1A
Charging Temperature.............................. 5°C to 40°C
Operating Temperature.............................. -18°C to 40°C
FUNCTIONAL
DESCRIPTION
1
2
3
4
1
LIGHT OUT OF
service facility for a
®
To reduce the risk of fire, personal
injury, and product damage due to a
chemicals, and
Do not charge non-rechargeable
batteries.
1. Indicator light
2. Light lens
3. Power button
4. USB port door
5. Magnet
REACH OF
bleach or
5