Advertisement

Mile Marker.G2
L O C K G U I D E
carolina.ofs.com
800.763.0212
03.25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Carolina Mile Marker.G2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ofs Carolina Mile Marker.G2

  • Page 1 Mile Marker.G2 L O C K G U I D E carolina.ofs.com 800.763.0212 03.25...
  • Page 2 Key lock specific . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . carolina.ofs.com 800.763.0212...
  • Page 3: Pearl Lock

    4. Close housing flip-up and move housing base to the closed position (fig . 3) . fig . 1 fig . 2 fig . 3 Note: Batteries must be installed correctly for lock to function . Make note of correct battery installation before removing the old batteries . carolina.ofs.com 800.763.0212 03.25...
  • Page 4 . Pearl was shipped with reset stickers – one should be attached to the back of the Pearl, and the extra sticker should be saved in a safe and secure location for future reference. carolina.ofs.com 800.763.0212 03.25...
  • Page 5 3. Rotate the knob to the unlocked position then press and hold (enter) for 3 seconds (yellow indicator light will illuminate) . 4 . With the yellow indicator light illuminated, programming can begin . Knob Indicator light: YELLOW indicates low battery or program mode Enter carolina.ofs.com 800.763.0212 03.25...
  • Page 6 (enter) to exit programming . Restore to factory default: • To restore the factory default supervisor and user code, type the Reset code assigned to the Pearl and press (enter) Indicator light: GREEN indicates button input and valid code Enter carolina.ofs.com 800.763.0212 03.25...
  • Page 7 1. Place Pearl into Programming Mode. 2. Type 8888 and then press (enter) 3. If successful, the green indicator light will illuminate for 1 second . • Continue programming or press 9 and then press (enter) to exit programming . carolina.ofs.com 800.763.0212 03.25...
  • Page 8: Mechanical Lock

    2. With each dial, spin until it stops . After setting each dial, the last used code will display. 3. Turn the knob back to LOCK postion and remove the key . Return the knob to UNLOCK and scramble the dials for the next user. carolina.ofs.com 800.763.0212...
  • Page 9: Padlock Hasp

    L O C K G U I D E P A D L O C K H A S P Assigned user mechanical dial lock: • Shackle should be less than 5/16" in diameter 1.2" 0.24" diameter 2.54" 4.55" 2.3" 1.7" carolina.ofs.com 800.763.0212 03.25...
  • Page 10: Key Lock Specific

    *PLUS* • Alike • Consecutive • Alike • Alike • Key 101 • Key 101 • Key 101 • Key 101 • Qty . 4 • Qty . 4 • Qty . 4 • Qty . 4 carolina.ofs.com 800.763.0212 03.25...

Table of Contents