Download Print this page

Unidare WMF Series Installation And Operating Instructions

Fan storage heater

Advertisement

Quick Links

WMF(N)
WMF 718N - 2.6kW / 18kWh STORAGE & 1.5kW BOOST
WMF 724N - 3.4kW / 24kWh STORAGE & 1.5kW BOOST
INSTALLATION
PLEASE READ THIS LEAFLET CAREFULLY AND RETAIN FOR FURTHER USE.
NOTE ALSO THE INFORMATION GIVEN ON THE HEATER
The Installation must be carried out by trained personnel.
A means for disconnection must be incorporated in the fi xed wiring by a double pole switch with a contact separation
of a minimum of 3mm and in accordance with the current IEE Wiring Regulations.
The heater must not be installed immediately below a fi xed socket outlet.
The heater is not suitable for connection to a 30A ring circuit.
Do not position the heater under windows where curtains can contact the heater casing.
WARNING - THE SURFACES ON THIS HEATER CAN BE HOT.
This heater meets EN60335 safety requirements. However, any heater type becomes hot in normal operation. Care must
be taken to ensure that prolonged skin contact with the heater does not occur.
WHERE YOUNG CHILDREN, INFIRM PERSONS, OR THE AGED ARE PRESENT THIS APPLIANCE MUST BE
ADEQUATELY GUARDED. Contact your installer or the manufacturer for further advice.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision for instruction concerning use of the
appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the
appliance.
This appliance is very heavy and must be securely fi xed to a wall. DO NOT UNDER ANY CIRCUMSTANCES ATTEMPT
TO MOVE OR REPOSITION THIS HEATER WITHOUT SEEKING EXPERT ADVICE.
To maintain stability, it is essential that the heater is placed on a level surface.
This heater must be installed where it is impossible for switches and other controls to be touched by a person using a bath
or shower.
IMPORTANT - Due to the newness of materials the heater will produce a slight smell for the fi rst few days of operation.
ROOMS MUST BE WELL VENTILATED AND YOUNG CHILDREN, CAGED BIRDS, OR PERSONS WITH RESPIRATORY
COMPLAINTS MUST NOT REMAIN IN CLOSE PROXIMITY TO THE HEATER DURING THE FIRST 48 HOURS OF THE
COMMISSIONING PERIOD.
IF, DURING ANY REASSEMBLY OF THE HEATER, A PART OF THE THERMAL INSULATION SHOWS DAMAGE OR
DETERIORATION WHICH MAY IMPAIR SAFETY, IT SHOULD BE REPLACED BY AN IDENTICAL PART.
FAN STORAGE HEATER RANGE
MODELS:
INSTRUCTIONS
IMPORTANT
OPERATING
AND

Advertisement

loading
Need help?

Need help?

Do you have a question about the WMF Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Unidare WMF Series

  • Page 1 WMF(N) FAN STORAGE HEATER RANGE MODELS: WMF 718N - 2.6kW / 18kWh STORAGE & 1.5kW BOOST WMF 724N - 3.4kW / 24kWh STORAGE & 1.5kW BOOST INSTALLATION OPERATING INSTRUCTIONS IMPORTANT PLEASE READ THIS LEAFLET CAREFULLY AND RETAIN FOR FURTHER USE. NOTE ALSO THE INFORMATION GIVEN ON THE HEATER The Installation must be carried out by trained personnel.
  • Page 2 INSTALLATION INSTRUCTIONS 2. Remove the inner font panel by unscrewing the screws along its top and sides. As the front insulation is attached care must be taken when lifting this panel from the heater and placing it to one side. WARNING - This appliance must be earthed 3.
  • Page 3 4. Ensure that any slack is pulled back 9. Carefully fi t the bottom row of the through each clamp and tighten the back layer of bricks placing the two end clamping screws. Secure cables to bricks into position fi rst. Ensure that the base of the heater using ties provided recess in the bricks is towards the rear in fi...
  • Page 4 OPERATING INSTRUCTIONS THE OUTPUT CONTROLS CLEANING This storage heater takes in Energy (i) FAN- Three position rocker switch when electricity tariffs are low and offering - releases it on demand. The added To maintain the appearance of the heater FAN OFF fl...

This manual is also suitable for:

Wmfn seriesWmf 718nWmf 724n