Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NAPCO UNIVKIT1
Summary of Contents for NAPCO UNIVKIT1
- Page 1 ® UNIVKIT1 Installation Instructions © NAPCO 2001 WI1078 05/01...
-
Page 2: Table Of Contents
WI1078 UNIVKIT1 Installation Instructions Features Table of Contents General Information • 3 Form C Relay Outputs General Information ........2 The UNIVKIT1 is a hand held, 2 button, 5 • 2 PGM Open Collector Outputs Specifications ...........2 channel wireless remote control device • Arm/Disarm Controls, Indicators and Wiring ....3... -
Page 3: Controls, Indicators And Wiring
Controls, Indicators and Wiring Diagram Receiver KeyFob Antenna Press simultaneously for panic alarm JP1 JP2 • • Press for Press for Mounting tabs Arm/Disarm Garage Door • Hold down Control Remove to for Stay • open housing Mode Hold down for special applications Enroll Mode LED... -
Page 4: Wiring For Arm / Disarm
WI1078 UNIVKIT1 Installation Instructions Wiring for Arm / Disarm Wiring for Panic Program a zone on the control panel for “Keyswitch Arm” Program a zone on the control panel as a 24 Hour Panic Zone. Choose the appropriate wiring scheme for your control panel. -
Page 5: Wiring For Stay Mode
Interior Zones if the system is armed and the exit/entry door is not opened. Program the control panel for “Automatic Interior Bypass”, or for “Home Away with Delay” (for the NAPCO Express Series stay mode). Each time the system is armed by a press of KeyFob button [I], the system will arm in the AWAY mode, providing complete protection. -
Page 6: Wiring For Garage Door Control
Wiring for Garage Door Control Using PGM2 to Control a Second Garage Door The UNIVKIT1 can be used to control a garage door opener, or any The UNIVKIT1 can be configured to control a second garage garage door opener, or a second access control device by utilizing other access control device which requires a momentary closure for a NAPCO RB1000 relay wired to the receiver PGM2 terminal. -
Page 7: Using Pgm2 For Special Applications
Using PGM2 for Special Applications Each Keyfob used on the system must be enrolled into the The UNIVKIT1 can be configured to control lighting or other receiver using the following procedure: special applications by utilizing a NAPCO RB1000, wired to the receiver PGM2 terminal. -
Page 8: Warranty
EXPRESS OR IMPLIED, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY THE NAPCO is not an insurer of either the property or safety of the user's family or employees, SELLER'S OWN NEGLIGENCE OR FAULT.
Need help?
Do you have a question about the UNIVKIT1 and is the answer not in the manual?
Questions and answers