Page 1: Table Of Contents
1600193 REV A TR3 TRIPOD KIT Part #: 32200; 32207; 4400000; 4400001; 4400002 Instruction Manual Contents Worker Classifications Applicable Safety Standards Weight Capacities Product Specific Applications Product Specifications and Materials Limitations Maintenance, Cleaning, and Storage Compatibility Installation and Use Inspection...
Page 2: Worker Classifications
Rescue/Confined Space: TR3 Tripod may work in order to eliminate hazards. be used in Rescue/Confined Space applications. Rescue systems function to Authorised Person: A person who is ...
Page 3: Specifications
Specifications TR3 Confined Space Tripod Head Pulleys (2) Eyebolt Attachments (2) Locking Tabs (3) Recovery Type Worm Gear Winch Fall Arrest (3-way SRL) (FABX2R or FABXLR) Mounting Bracket Leg Pins (3) Anti-splay Webbing Swivel Feet (3) Materials Aluminium, stainless steel, galvanised steel,...
Page 4: Part Specifications
Locking Pins and Hitch Pins Tripod Attachment Location Part Specifications Kit # Part # Description 32200 TR3 Tripod & Carrying Bag (32208) 32207 32200 TR3 Tripod & Carrying Bag (32208) 32201 65 ft (19,8 m) winch and adaptor bracket 4400000 32200 TR3 Tripod &...
Page 5 Opening and Clearance Opening Diameter:  3.2 ft (1 m) (tripod maximum extension) 1.6 ft (0,5 m) (tripod minimum extension) Minimum Distance Foot to Opening:  0.65 ft (0,2 m) Minimum Head Clearance:  3.9 ft (1,2 m) (ground to obstruction distance) Maximum Tripod Diameter: 4.6 ft (1,4 m) ...
Page 6: Limitations
Maintenance, Cleaning, Limitations and Storage Fall Clearance: There must be sufficient clearance below the work surface to arrest a Cleaning after use is important for maintaining fall before the user strikes the ground or an the safety and longevity of the system. Remove obstruction.
Page 7 TR3 and RTFA Installation and Use Step 2  Release leg pins and This tripod used in combination with Guardian slide up to desired RTFAs with rescue functions are designed for fall height. arrest and rescue only. If the tripod is to be used...
Page 8 Step 6 Step 10   Feet can be swiveled Pull cable up to tripod for storage and use on head and insert hook certain surfaces. Eg: through central hole. hard surface (a), or soft ground (b). Step 7 Step 11 ...
Page 9: Winch Installation
 NOTE Step 1 Guardian Fall Protection requires  the TR3 Tripod be used with a compatible Setup TR3 to desired height. On leg with SRL certified for use in Rescue/Confined pulley, identify installation location. Space applications, such as the 3-Way SRL (part #s 10974 and 10981).
Page 10: Operation
Never use the equipment near moving  machinery, electrical hazards, sharp, or abrasive surfaces. Never use this equipment in a manner other  than as described in this user manual. For questions, contact Guardian immediately.
Page 11: Installation And Use
Installation and Use Without Fixed Access With Fixed Access When a confined space has no fixed access system and there is a need to lower the user When a confined space has a fixed access down under control, you should use: system, such as a ladder, installed the user Tripod ...
Page 12 Step 2  rescue/retrieval (to raise or lower a worker Select desired height of 3-Way SRL on TR3 that has experienced a fall). Tripod leg, and place Mounting Bracket at  NOTE For routine personnel or material location.
Page 13 Step 3  Install (2) provided Locking Pins through Mounting Bracket and TR3 Tripod leg, as shown. Top locking pin goes through the leg of tripod and bottom locking pin goes behind the leg, as shown. Step 4  Secure Locking Pins with connected hitch pins, and ensure Mounting Bracket is fully secured to TR3 Tripod leg.
Page 14 TR3 Tripod Pulley and down Step 2  through top of TR3 Tripod, so that it hangs over confined space entry location. Re-insert Latch 3-Way SRL Swivel Eye over hook on Detent Pin to ensure cable will stay in line with Mounting Bracket, then lower 3-Way SRL into Pulley.
Page 15 If handle continues Never use this equipment in a manner other to rotate or load moves without user input,  than as described in this user manual. For cease operation and immediately remove the questions, contact Guardian immediately. device from service.
Page 16: Inspection
Inspection Pre-use Inspection: Check the head and leg pins for signs  Prior to EACH use, inspect the device, life line, of wear or damage and replace wear and connection points for signs of deficiencies, necessary. including, but not limited to, corrosion, deformation, pits, burrs, rough surfaces, sharp Pay attention to condition of leg tubes for ...
Page 17: Safety Information
Safety Information Harnesses and connectors selected must be compliant with manufacturer’s instructions, and  WARNING! Failure to understand and must be of compatible size and configuration. comply with safety regulations may result in Snap hooks, carabiners, and other connectors serious injury or death. Regulations included must be selected and applied in a compatible herein are not all-inclusive, are for reference only, fashion.
Page 18: Labels
If used for equipment hois�ng, maximum equipment weight is 551 lbs./250 kg. Worker capacity range (including all All equipment used in combina�on with TR3 MUST be equipment): 130-310 lbs./59-141 kg. selected and deemed compa�ble by Competent Person. If used in assisted rescue, maximum combined Keep away from all poten�al hazards including, but not...
Page 19 Labels 60MM Manufactured in the UK by Checkmate Lifting & Safety Ltd Model #: 32200 DOM: Serial #: Model #: 32200 Serial Number ANSI Z359.18-2017 & A10.32-12 / OSHA 1926 Sub M & 1910 Type A Anchorage connector ANSI Z359.18-2017 & A10.32-12 / OSHA 1926 Only make compa�ble connec�ons Sub M &...
Page 20 Diagram A - Fall Clearance Max. Arrest Distance Fall clearance calculation shown below is based SQUARE-S Harness Stretch SQUARE-S on a standing worker falling directly in-line with Safety Factor SQUARE-S anchor point. Swing Fall SQUARE-S 4.5 ft (1,4 m) 1.5 ft (0,45 m) 2 ft (0,6 m) Swing Fall 4.5 ft (1,4 m)
Page 21 Diagram B - Connections      ...
Page 22: Inspection Log
Inspection Log Serial No: Date: Model #: User: Date: Condition: Inspected by:...
Page 23 Notes...
Page 24 This warranty is not transferable to any other Guardian service and does not apply to product that is resold after having been put into service. No other person, firm, entity, or the like is authorized to assume or assign for Guardian any other liability in connection with the sale or use of Guardian’s products.

This manual is also suitable for:

32200 32207 4400000 4400001 4400002

Guardian TR3 Instruction Manual

Quick Links

Need help?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Guardian TR3

Summary of Contents for Guardian TR3

This manual is also suitable for:

Table of Contents